RECON 264143 User Manual

RECON Ford 5-Piece LED Cab Roof Light Installation

PART #’s: 264143AM (amber lens), 264143BK (smoked lens), & 264143CL (clear lens)

Email: [e-mail]

Website: http://www.reconaccessories.com

This document covers the installation of RECON Truck Accessories 5-Piece LED Style
running lights on a 2005 Ford F250 Superduty that DID NOT come with factory installed
running lights on the roof. You must supply the wiring harness which can procured at
any Ford dealer nationwide & many auto parts stores located throughout the country.
You can also improvise and make your own “harness” by simply getting approx 7 feet of
wire to run down the pillar and splice into the positive parking light lead on the fuse
panel while grounding the negative wire coming off each cab light to the screw you used
in the roof to hold the cab lights in place.

RECON offers three different color lenses: Amber, Clear, Smoked

RECON 5-piece Ford LED Cab Roof Light Kit Boasts the Following:

 Provides Maximum Visibility
 Meets DOT & S.A.E. specifications
 Replaces entire factory cab lights if you choose to replace the entire factory unit
 Super Bright Amber ¼ watt LEDs
 Kit is universal & can be installed on nearly every make and model of vehicle
 Great-looking Retail-Friendly Packaging

The light kit comes with everything required to install, except it is also recommended
that you apply a little silicone/sealant to ensure a lasting seal around the holes & wires if
you are installing on a vehicle that did not come with factory installed cab lights as
drilling is required.

Overview

The installation takes approximately 2 to 3 hours and can be broken down into 4 main
steps:

1. Drop front part of headliner

2. Measure/Mark holes for lights

3. Mount Lights

4. Wire Lights & Re-assemble

RECON Truck Accessories 2008 Page 1 of 5 Installation Instructions Part # - 264143 Series

Installation Procedures for Factory FORD Clearance Lights

One of the options folks want when they purchase their truck, are factory clearance lights. As dealers charge more than

$300 to install them, many folks choose to do it themselves. All that’s needed is a Ford wiring harness that comes installed
in the roof of trucks with factory installed clearance lights. The complete wiring harness is approx $30.00. You may have
to make a trip to a local hardware store such as Lowe’s or Home Depot to get flat washers and Nylock 5mm nuts for the
lights and a tube of clear silicone.

First thing you need to do is cover your dash to keep
shavings and stuff from falling into your interior. You have
to take down the front of your headliner to access the area for
the cab lights and to remove and install the harness. Remove
the plugs on the handle on the passenger side and then

remove the (4) bolts holding the handle on.... required a

5/16" socket.

Once the handle is removed, pop the pillar cover off. To get
it out tilt towards the drivers side and wiggle. It will come
out! Same thing with driver’s side.

Now you need to remove all the screws that hold the visors

parts in....

RECON Truck Accessories 2008 Page 2 of 5 Installation Instructions Part # - 264143 Series