www.recom-international.com PO 43August 2002
Specifications (typical at nominal input and 25°C unless otherwise noted)
Output Power 15W max.
Voltage Accuracy (full Load and nominal Vin) ±1%
Minimum Load (see note 1) 10% of FL
Line Regulation (LL-HL at full load) ±1%
Load Regulation (10% to 100% FL) Single ±1%
Dual ±2%
Cross Regulation (asymmetrical load 25%/100% FL) Dual ±5%
Ripple and Noise (20MHz bandwith) Single 50mVp-p
Dual 75mVp-p
Temperature Coefficient ±0.02%/°C, max.
Transient Response (25% load step change) 500µsec
Over Voltage (with zener diode clamp) 3.3V output 3.9V
5V output 6.2V
12V output 15V
15V output 18V
Over Load Protection (% of full load at nominal Vin) 150% max.
Short Circuit Protection Hiccup, automatic recovery
Input Voltage Range RP15 12V nominal input 9-18VDC
RP15 24V nominal input 18-36VDC
RP15 48V nominal input 36-75VDC
Input Filter Pi Type
Input Surge Voltage (100 ms max.) 12V input 36VDC
24V input 50VDC
48V input 100VDC
Input Reflected Ripple (nominal Vin and full load, see note 2) 20mAp-p
Start Up Time (nominal Vin and constant resistor load) 20ms typ.
Remote ON/OFF (see note 3) Positive logic DC-DC ON Open or 3.5V < Vr < 12V
DC-DC OFF Short or 0V < VR < 1.2V
Negative logic DC-DC ON Short or 0V < Vr < 1.2V
DC-DC OFF Open or 3.5V < Vr < 12V
Remote Off Input Current Nominal input 2.5mA
Efficiency see „Selection Guide“ table
Isolation Voltage 1600VDC min.
Isolation Resistance 109Ω min.
Isolation Capacitance 300pF max.
Switching Frequency Single output 500kHz typ.
Dual output 300kHz typ.
Approved to Safety Standards UL 1950, EN60950
Case Material Nickel-coated copper
Base Material Non-conducted black plastic
Potting Material Epoxy (UL94-V0)
Weight 27g
Dimensions 50.8 x 25.4 x 10.2 mm
MTBF (see note 4) 2.041 x 10
6
Hours
continued on next page
POWERLINE - DC/DC-Converter
F-Series, 15W, 1.6 kV Isolation, 2:1 Wide Input Range (Single & Dual Output)