PO 23www.recom-international.com August 2002
Specifications (typical at nominal input and 25°C unless otherwise noted)
Output Power 5W max.
Voltage Accuracy (full Load and nominal Vin) ±2%
Minimum Load (see note 1) 10% of FL
Line Regulation (LL-HL at full load) ±0.2%
Load Regulation (25% to 100% FL) Single ±0.5%
Dual ±1%
Cross Regulation (asymmetrical load 25%/100% FL) ±5%
Ripple and Noise (20MHz bandwith) 50mVp-p
Temperature Coefficient ±0.02%/°C, max.
Transient Response (25% load step change) 200µsec
Over Load Protection (% of full load at nominal Vin) 170% typ.
Short Circuit Protection Continuous, automatic recovery
Input Voltage Range RP05 12V nominal input 9-18VDC
RP05 24Vnominal input 18-36VDC
RP05 48V nominal input 36-75VDC
Input Filter Pi Type
Input Surge Voltage (100 ms max.) 12V Input 36VDC
24V Input 50VDC
48V Input 100VDC
Input Reflected Ripple (nominal Vin and full load) 20mAp-p
Start Up Time (nominal Vin and constant resistor load) 600ms typ.
Efficiency see „Selection Guide“ table
Isolation Voltage In to out 1600VDC min.
I/O to case DIP type 1600VDC min.
I/O to case SMD type 1000VDC min.
Isolation Resistance 109Ω min.
Isolation Capacitance 300pF max.
Switching Frequency 300kHz typ.
Approved to Safety Standards UL 1950, EN60950
Case Material Nickel-coated copper
Base Material Non-conducted black plastic
Potting Material Epoxy (UL94-V0)
Weight DIP 16g
SMD 18g
Dimensions See „Package Style and Pinning“ on next page
MTBF (see note 2) 3.165 x 106hours
Operating Temperature Range Standard -25°C to +85°C (with derating)
M1 (see note 3) -40°C to +85°C (non-derating)
Maximum Case Temperature +100°C
Storage Temperature Range -55°C to +105°C
continued on next page
POWERLINE - DC/DC-Converter
A-Series, 5W, 1.6 kV Isolation, Regulated, 2:1 Wide Input Range (Single & Dual Output)