RearviewSafety RVS-splitter User Manual

Page 1
Quad box brief manual
Front side of quad box
Power cable
Red: DC9-36V input positive Black: input ground Red (not in the black tube): DC12V output Black(not in the black tube):ground Brown: trigger wire of camera 1 Blue: trigger wire of camera 2 Yellow: trigger wire of camera 3 White: trigger wire of camera 4
Page 2
Video output cable
This video cable must be used , otherwise the quad box cant work normally.
Key board (optional accessory)
Operation instruction:
1\After turn on the quad box (power indicate light show green), keep pressing MENU key for 3 seconds , the screen will show following picture:
Page 3
Keep pressing MENU key for 3 seconds , the quad box will exit the menu.
2\Press ENTER key to enter the SYSTEM SETUP , the screen will show following picture :
Page 4
CAMERA PRORITY: User can choose NO PRIORITY ( 4 trigger wires have same priority;or
CAM1 ( trigger wire for CAM1 has highest priority , when it is using , the other 3 trigger wire dont function ) VCR OUT(assistant video output connector to connect DVR or other monitor ):User
can choose QUAD/CAM1/CAM2/CAM3/CAM4/None
POWER ON OUTPUT : user can choose no output
/quad/CAM1/CAM2/CAM3/CAM4/Splite1-2/Splite 3-4 If choose no output , means the quad box will on stand by mode ( power indicate light show red) after get power supply , user must press POWER” key to turn on the monitor .
3\Enter the DISPLAY SETUP , the screen will show following picture
4\Enter the TIME SETUP , the screen will show following picture
Page 5
Auto sequence means the quad box will show camera1,2,3,4 on full screen by turn , the default display time for each camera is one second . There are 2 way to use the AUTO SEQUENCE function :
(1)Press the AUTO key on the quad box ; (2) Press the key on the key board ,the screen will show quad vision ,then
press again ,the screen will show camera from 1-4 by turn . Hold time means the camera image delay time on the screen after the trigger wire operation is over.
5\Enter the CAMERA SETUP , the screen will show following picture :
User can adjust the BRIGHTNESS/Contrast/SATURATION/HUE/SHARPNESS parameter from -24 to +24 MIRRORING :OFF means the quad box show camera by normal image MIRRORING :ON means the quad box show camera by mirror image
Video input : 4 channel (CAM1 has audio input ) Video output :1 channel Video output : 1 channel (from camera 1 audio) Power input : DC9-32V
Loading...