Realistic 32-1200C User Manual

*

CAT. NO. 32-12000

O W N E R ' S M A N U A L

Please read before using this equipment

STEREO MIXING CONSOLE

FEATURES

Your Realistic Stereo Mixing Console is c sophisti
cated control center for all your mixing needs —

recording, live performances, or playback of mul

tiple sources from your home stereo.

The "state of the art" circuitry in this mixer ensures
quiet, dependable performance in your home or

for professional use.

You will find almost limitless combinations of this

mixer's many features. And the more you use the

Mixer, the more combinations you will find.

Pan Pots — are used to permit total stereo con
trol of three microphone inputs.
Two pairs of stereo phono inputs — let

you connect two turntables with magnetic car
tridges, two turntables with ceramic cartridges, or

one of each.

Tape input — for a stereo tope deck or other
high level source.

Auxiliary input — for compact disc player. Hi

Fi VCR, another stereo tape deck or any high level

source.

Tape output — for either tape recording or

monitoring.

S ev en G L ID E- PA T H ® l ev e l c o n t r o l s — f o r

finger-tip adjustment of sound mixing and fading.

A cue function — that allows you to listen to
and check a phono, tope or aux signal, using

headphones, before putting it "on the air".

Dual VU meteres — for monitoring output

levels.

Two slide switches — for selecting inputs

(phono 1 or tape, phono 2 or aux).

Mono/stereo switch —to send mono signals
to both output channels.

Headphone jack — for listening to the cue

function, or monitoring the main output.

SPECIFICATIONS

Input Impedance:

M i c 1 , 2 a n d 3 3 3 k o h m s

Phono Mag 1 and 2 50 k ohms

P h o n o C e r a 1 a n d 2 1 M o h m s

T a p e I n 1 0 0 k o h m s

A u x 1 0 0 k o h m s

Output Level:

Tap e Ou t 55 0 mV

Main Out 550 mV

Sensitivity for Rated Output:

M i c 1 , 2 a n d 3 1 . 0 m V

Phono Mag 1 and 2 2.0 mV

Phono Cera 1 and 2 220 mV

T a p e / A U X 8 0 m V

Note; MASTER VOLUME and all controls are

at 70% position.

Frequency Respons e: 10 — 30 kHz

S/N Ratio

M i c 7 3 d B

Phono Mag 1 and 2 75 dB

Phono Cera 1 and 2 62 dB

T a p e / A U X 7 8 d B

T.H . D . a t r at e d o u t p u t : 0 . 2 %

Note: MASTER VOLUME and all controls are

at 70% position.

Phono Eq. Response: RIAA ± 2dB

Channel Separation at 1 kHz: 56 dB

Monitor Output, at 8 ohms load: .... 35 mV

AUX. Level Control = 70% position

MONITOR LEVEL Control = MA X., AUX 80m V

input

Maximum Input Level:

M i c 1 , 2 a n d 3 2 5 0 m V

Phono Mag 1 and 2 250 mV

Phono Cera 1 and 2 . . more than 3.0 V

T a p e / A U X I n fi n i t i v e

(at Master volume with Max. position, rated

output, T.H.D. 1.0% point)

Power Requirements:

AC 120V, 60 Hz for U.S.A./Canodo

AC 220/240V, 50 Hz for Europe

AC 240V, 50 Hz for Australia

For your permanent records, we urge you to

record the serial number of this unit in the space

provided. You'll find the serial number on the bock
panel of the unit.

Serial Number

WARNI NG:

To prevent fire or shock hazard, do not expose this ap

pliance to rain or moisture.

ni SK O F EU CI I II C SH OC K

00 NOT OPEN

CAUTION: TO REDUCE THE RISK OF ELEaRIC

SHOCK, DO NOT REMOVE COVER (OR BACK).

NO U SE R -S ER VIC EA BL E PAR TS I NS ID E. RE FE R

SE RV IC ING TO QUA LIF IE D SER VICE PE RSO NN EL .

The lighting flash with arrowhead symbol
within on equilateral triangle, is intended to
alert the usertothepresenceof uninsulated

"dangerous voltage" within the product's

enclosure that may be of sufficient mag

nitude to constitute a risk of electric shock to

persons.

The exclamation pointwithin on equilateral

triangle is intended to alert the user to the

presenceofimportontoperoting and main

tenance (servicing) instructions in the litera

ture accompanying the appliance.

© 1990 Tandy Corporation.

All R igh ts Re serv ed.

Radio Shack and Reaiistic are registered trademarks of Tandy Corporation.

2

CON T RO L S A ND FUN C TI O NS

■ n m q u i

h I = n I , I

0 * 0< JT O -c x J r I ^ ^

W '®' 'fll)'

m [ a ]

=4i=?=rt='.°=ft:?=rh=:=r=

® POWER Switch:

Turns the Mixer's power on and off.

(2) MONO/STEREO Switch:

When pressed, it combines the left and right
channels, and allows you send a mono input

to both outputs or send stereo input to mono

amplifier.

(D MASTER VOLUME Control:

Adjusts the output level of all the sources
simultaneously.

0 PHONO 2/AUX Level Control:

Controls the volume of the input selected with

the PHONO 2/AUX Switch.

(5) FADER Control:

Lets you moke a smooth transition from the

PHONO 1/TAPE input to the PHONO 2/AUX

input, using only one control. In the center po

sition the two inputs are blended equally.

0 PHONO 1/TAPE Level Control:

Controls the volume of the input selected with

the PHONO 1/TAPE Switch.

® MONITOR LEVEL Control:

Adjusts the headphone volume level from the
CUE or MAIN OUTput.

0 Headphone Jock:

For listening to the MAIN OUTput or CUE,
using stereo or mono headphones.

0 Microphone Level Controls:

Allows you to adjust the level of each micro

phone independently (0 is off, and 10 is

maximum).

0 PAN POT Controls:

Adjusts each micro>phone's apparent position
in the "stereo image" from left to right, or any

where in between.

0 LEFT and RIGHT VU meters:

Indicates the output signal levels.

0 PHONO 1/TAPE Switch:

Selects an input source, either turntable 1 or

tope deck.

0 CUE Switches:

Permits the monitoring of the signal from

PHONO 1/TAPE or PHONO 2/AUX {using

headphones), without sending it to the MA\N

OUTput.

0 PHONO 2/AUX Switch:

Selects on input source; either turntable 2 or

the auxiliary input.

3