Real Flame 2610B Instruction Manual

Model # 2610B

Modèle # 2610B

Instruction Manual

Manuel d'instruction

Instructions and warnings for use.

STOP!

If parts are missing or damaged, call 1-800-654-1704 for assistance

Welcome to the Real Flame® family of gel fuel products. If you have any questions
please call customer service at

1. Log set is designed to be used with Real Flame gel fuel only. Do not use with any other gel fuel or any other flammable
liquid or gel.

2. Read entire label and instructions before using Real Flame gel fuel.

3. Never leave a burning fire unattended, especially around children or pets.

4. When burning in an existing fireplace, be sure that the material surrounding the logs is non-combustible and it is clear
and free of all flammable materials.

5. Firebox must be brick, cement, steel or other non-flammable material because there will be a real fire inside.

6. Never touch logs or grate during or after burning gel fuel. Logs and grate will be extremely HOT. Allow logs, grate and gel fuel
cans to cool for 60 minutes before touching.

7. Do not burn more than three cans of fuel at once.

8. Keep away from children and pets. Log set is not to be operated by children.

9. Make sure log set and gel fuel are burned on a flat and level surface.

10. Do not alter log set in any matter.

11. Do not store or use gasoline or other flammable vapors or liquids in the vicinity of this product.

12. Do not wear flammable or loose clothing when operating the outdoor gel log set.

13. Do not attempt to move or store the log set until 60 min after gel fuel cans have been extinguished.

14. Do not lean over log set when lighting or when in use.

15. Do not burn gel fuel outside designated burn areas on the metal plate.

16. In case of an emergency use a CO2 extinguisher to extinguish the fire.

17. Death, serious injury or damage to property may occur if the above is not followed exactly.

18. If for any reason you cannot follow these warnings please call us at 1-800-654-1704.

1-800-654-1704 or log on to www.REALFLAME.com.

WARNINGS

!

!

!

!!

®

NOTICE: Buyer assumes all responsibility for safety and use that is not

in accordance with instructions and warnings.

Using your Log Set

- Log Set is designed for use in your existing indoor fireplace.

- Follow all instructions included with gel fuel before use.

- Before using Gel Conversion Log Set make sure you have read and understand the step-by-step instructions.

- During the inital burn you may experince a slight odor. This odor is temporary and will be absent on following burns.

®

Rev. 04/30/07

2610 Birch Conversion Log Set
Instructions

Parts List

Number Description Part Number Quantity
1 Left Log 2609-B D 1

2 Middle Log 2609-B B 1
3 Right Log 2609-B C 1
4 Front Log 2610-B E 1
5 Rear Log 2610-B F 1
6 Grate 2610-B G 1
7 Lift Assembly 2610-B H 1
8 Lift Assembly Leg 2609-B I 1
9 Lava Rock 4090 1 Bag
10 1” Phillips Head Bolt 9742 12

®

Before starting assembly, review
parts list making sure you have all
the pieces in good condition. If there
are any damaged or missing parts
please call customer service at
1-800-654-1704

Before using fireplace read and
understand all instructions and safety
precautions included with this log
set.

Step One

Figure 1

With Grate (6) set on a flat surface, locate Lift Assembly Leg (8). From the rear
attach Lift Assembly Leg to the right side of the grate as shown in figure 1 with
two bolts. Make sure that there is a hole at the top of the leg that points toward
the left side of the Grate.

8

8

6

Figure 1