Page 1
BLITZ
SURGE PROTECTOR
USER’S MANUAL
Page 2
Technical support: www.real-el.com
1
User’s Manual
ENG
BLITZ
Congratulations on purchasing the ТМ REAL-EL surge protector!
Please read this User’s Manual before using the unit and retain this User’s
Manual in a safe place for future reference.
COPYRIGHT
© 2015. ENEL GROUP OU.
This Manual and information contained in it are copyrighted. All rights reserved.
TRADEMARKS
All trademarks are the property of their legal holders.
NOTICE OF RESPONSIBILITY RESTRICTION
Despite the exerted efforts to make this Manual more exact, some discrepancies may occur. The information in this Manual is given on “as is” terms.
The author and the publisher do not bear any liability to a person or an organization for loss or damage which has arisen from the information contained
in this Manual.
PACKAGE CONTENTS
• Surge protector – 1 pc
• User’s manual – 1 pc
• Warranty card – 1 pc
PURPOSE
REAL-EL BLITZ surge protector is designed to protect household appliances and computers. The device falls in surge protective devices of the limiting type.
Page 3
Technical support: www.real-el.com
2
ENG
Surge Protector
BLITZ
SPECIAL FEATURES
• Lightning discharge protection
Filter protective elements prevent the destructive effect of the lightning
discharge to an electrical appliance connected to it.
• Protection against impulse interference in the mains
• Built-in thermal protection
• Visual indication of the protection status and the mains
• Ground contacts
• Protecting shutters
• Shockproof flame-retardant case
DESIGN DESCRIPTION
The mains status indicator
Protection status indicator
Ground contacts
Protecting shutters
Plug
PREPARATION AND
OPERATION
• Connect the surge protector
to 230 V mains.
• Connect required electrical appliance to the surge protector socket. The
load must not exceed 3.6 kW.
• If the mains and filter protection circuit are in normal condition, indicators
and are active.
SAFETY PRECAUTIONS
• Do not connect simultaneously the load to the surge protector with total
power more than 3.6 kW.
• It is not recommended to connect the surge protector to the nonsinusoidal
voltage sources: UPS, DC-AC inverters etc.
POWER PROTECTED
Fig. 1
Page 4
Technical support: www.real-el.com
3
User’s Manual
ENG
BLITZ
Notes:
• Technical specifications given in this table are supplemental information
and cannot give occasion to claims.
• Technical specifications and package contents are subject to change
without notice due to improvement of ТМ
REAL-EL
production.
• It is recommended to connect the surge protector to a grounded socket.
• If the protection status indicator is out of order, the surge protector
should be replaced for a new one.
• When signs of failure are found (for example, the output voltage absence
in a socket), mechanical damages, high temperature of the item or the odor,
the item must be disconnected from the wall socket immediately and you
should address to a service center.
• Do not open and never attempt to repair the item by yourself, it should be
repaired by qualified persons only.
TECHNICAL SPECIFICATIONS
Parameters and measurement unit
Voltage, V
Frequency, Hz
Maximum load, А
Maximum impulse current, А
Maximum dissipated energy, J
Thermal protection, °С
Output socket type
Value
~230
50
16
6000
2 × 125
11 5
1 × CEE 7/3
Page 5
Model: BLITZ
Manufacturer: ENEL GROUP OU, Katusepapi tn 6, Lasnamäe district, Tallinn city,
Harju county, 11412, Estonia. Made in China.
® Registered Trademark of ENEL GROUP OU. Estonia.
Loading...