Defect Checking
1.) Check whether the packaging box is broken. Find whether there is an
defect.
2.) Check the Box Contents – please check the attached image
3.) Check whether there are any defects on the product, USB cable, charger.
Turning On
1.) Remove the battery isolation tab from the bottom of the receiver to
turn on the receiver.
**Please note that the tab is the only way to turn off the receiver
2.) Plug the USB adapter into your wall socket. The receiver will power on
and the internal battery will start to charge. If the power is not supplied,
the inner light of the receiver will turn orange and flash. “Power
Disconnected” voice reminder will also played (30 sec interval).
**The internal battery is for emergency back-up only. For normal
operation, the unit should be connected to the mains power supply via
the USB adapter and port.
3.) Twist and remove the Transmitter base to expose the battery
compartment. Insert the AAA batteries as indicated by the + and indicators.
**If the transmitter’s battery is low, the inner light of the receiver will turn
orange and flash. “Battery Low” voice reminder will also be played (30 min
interval).
Setting Transmitter IDs
**The Voice Alert is able to pair up to 8 Transmitters with a single Receiver.
There is no limit to the number of Receivers that can be paired with a single
Transmitter.
1.) Set the transmitter’s ID using
the DIP switch. Make sure each
transmitter has a unique ID
number.