Ready Access AA100 Service Manual

AA100

Access Air 100

Air Curtain System

TABLE OF CONTENT

Topic

Disclaimer 3
Serial Number Identification 3
Introduction 3
Product Information
Specifications 4
Dimensions 4
Safety Information 4
Installation Procedures
Physical Installation 5
Electrical Installation 7
Operations
Modes of Operation 8
Maintenance
Maintenance Schedule
Daily 8
Monthly 8
Yearly 8
Service
Troubleshooting Guide (Cause and Effect) 9
Parts Lists
Parts List (Description/Part Number) 9
Schematics
Electrical Wiring Diagram / Warranty 9 / 11

Page

2

DISCLAIMER

Ready Access Disclaims any Liability for any damage or harm caused to the AA100 Air Curtain, it’s
operator or any other equipment however caused if the AA100 Air Curtain is repaired or serviced by
anyone other than an authorized service engineer or Contrary to the manufacturers written
instruction contained herein.

This manual is intended for use by the in-house or authorized field service engineers and sales
representatives

The manufacturer maintains the right to update, add or issue a new service manual at any time
without notice, thereby rendering all previous issues obsolete.

Please write the Serial Number and Installation Date for your drive-thru window in the spaces
provided.

SERIAL NUMBER

Date of Installation

.

The Serial Number
Nameplate Is Located
on the Face Panel.

INTRODUCTION

The Ready Access AA100 Pass-Thru Air Curtain System is designed to be an integral part of your
drive-thru operation by protecting your workplace against the entry of insects and exhaust fumes,
while increasing energy efficiency by reducing air conditioning losses. Also satisfies health
department codes for fly fan applications.

3

Product Information

SPECIFICATIONS AND PERFORMANCE

Model

Number

AA100 110/120 VAC

Dimensions

Unit Voltage

USA

60Hz

Single Phase

Actual

Unit

Amps

5 A

Air

Velocity

High / Low
2000/1800

FPM at Nozzle

Dimensions

In Inches

W x H x D

See Below

Weight

In Shipping

Carton

29 lbs

12" (305mm)

22" (559mm)

11 - 3/4" (299mm)

Figure 1

SAFETY INFORMATION

WARNING: To avoid the risk of Fire, Electric Shock or Injury to persons, observe the following:

Use this unit only in a manner intended by the manufacturer. If you have any questions, contact the
manufacturer.

Before servicing or cleaning the unit, switch the power off at the mechanical switch near the unit (Installed by
an Electrician) or the electrical entry service panel/circuit breaker. (Load Center)
OSHA LOCK OUT – TAG OUT procedures are to be observed to prevent power from being switched on
accidentally.

Any Installation and / or Electrical work must be done by QUALIFIED persons in accordance with all
applicable codes / standards and manufacturers recommendations and specifications.

When cutting into the wall or ceiling, DO NOT damage electrical wiring and/or other hidden utilities.

DO NOT use this fan with any solid-state speed control device.
DO NOT insert fingers and / or foreign objects into the Air Curtain.
DO NOT block or tamper with the unit in any manner while it is in operation.
DO NOT attach ductwork to this product or attempt to use it as a make-up air heater.

Such use voids the warranty and may create unsafe conditions.

This product must not be used in Potentially Dangerous locations such as Flammable, Explosive Chemical –
laden environment.

4