RDL WDG1R Datasheet

ACCESSORIES

Model WDG1R

Table Top Wedge Mount

The WDG1R is a tabletop enclosure for mounting any RACK-UP module. All steel construction.

Front

Rear

With Product Installed
(RU-SH1 available separately)

RDL • 659 6th St. • Prescott, AZ., USA 86301 • [phone] • FAX [phone] • www.rdlnet.com

ACCESSORIES

Model WDG1R

Table Top Wedge Mount

NOTE: When installing a RACK UP product that is in a
plastic box start by removing the screws from the back
of the RACK UP. Bend the tabs on the mounting unit up
at a 90° angle. Secure the unit to the mounting chassis
using the screws. Continue to Step 3.

Installation/Operation

Declaration of Conformity available from rdlnet.com.

Sole EMC specications provided on product package.
Specications are subject to change without notice.

STEP #1
Start the screws into the bottom of the RACK-UP but do not install
them all the way. Place the RACK-UP onto the chassis. The screw
heads will pass through the rear position in the cutout.

STEP #2
Slide the unit forward until the screws are seated in
the forward position of the cutout. Tighten the screws
to secure the unit in the chassis. A black laminate is
provided to cover these two holes. If desired adhere the
laminate to the chassis now.

STEP #3
Secure the chassis to the surface with screws.

891-5545A

U.S.A. [phone], [phone]; Fax: [phone]

Europe [NH Amsterdam] (++31) 20-6238 983; Fax: (++31) 20-6225-287

(Bottom View)

NOTE: If the unit will not be permanently mounted to a
surface skip Step 3. Instead install the included feet using
the 6-32 screws. Install the feet in the locations shown on
the above drawing. Continue to Step 4.

STEP #4
Slide the top cover toward the chassis. Once seated secure
the top cover to the chassis with the four included screws.

Radio Design Labs Technical Support Centers