RDL TX-PD8X Data Sheet

x
TX
ma
SERIES
Model TX-PD8X Switching Power Supply Distributor
Distribution of 24 Vdc Power Soft-Start from Switching Supply Directly Controllable by RDL Remote Controls Up to 8 Power Distribution Points Voltage Presence Indication Reverse Voltage Protection Outputs may be Activated by an External Switch Outputs may be Activated by an Open-Collector closure to ground 8 DC Power Cables Included
APPLICATION: The TX-PD8X is the ideal choice where power distribution from a current-limited switching power supply is needed. It is suitable for powering up to eight modules from a single power supply. The current limiting circuitry in many switching power supplies will cause the supply to shut down upon power-up when a high current capacitive load is connected. Upon application of power, the TX-PD8X ramps the voltage up, charging any load capacitance as quickly as possible, then switching full voltage to the load. If reverse polarity is connected to the input, the TX-PD8X disconnects the load until the condition is corrected.
In system design, various modules are frequently operated from a single power supply. Good engineering practice requires that the power wiring to each module originate at the power supply output. The TX-PD8X serves as the power source for each of eight modules. The TX-PD8X normally provides power to ground-referenced modules. A front-panel switch permits the installer to enable external control. When the ON terminal is connected to ground, the TX-PD8X outputs are active. External control is possible using RDL detection or control modules, open-collector outputs from OEM equipment or controllers, or using a D-RT2 RDL remote wall control. The front-panel blue LED remains illuminated when the outputs are active.
RDL  659 N. 6th St.  Prescott, AZ., USA 86301  (928) 443-9391  FAX (928) 443-9392  www.rdlnet.com
x
TX
ma
SERIES
Model TX- TX-PD8X Switching Power Supply Distributor
Installation/Operation
EN55103-1 E1-E5; EN55103-2 E1-E4
Typical Performance reflects product at publication time exclusive of EMC data, if any, supplied with product. Specifications are subject to change without notice.
TYPICAL PERFORMANCE
Input/Output Voltage: 24 Vdc @ 2 A (Intended for use with current limited switching supply) Outputs (8) : Total load current must not exceed 2 A (8 DC Power Cables Included) Indicator: POWER LED Power Requirement: 24 Vdc @ 25 mA plus connected loads Ambient Operating Environment: 0° C to 50° C
U.S.A. (800) 933-1780, (928) 778-3554; Fax: (928) 778-3506
891-7130
Europe [NH Amsterdam] (++31) 20-6238 983; Fax: (++31) 20-6225-287
Radio Design Labs Technical Support Centers
Loading...