RDL ST-PBR4 Data Sheet

ACCESSORIES

Model ST-PBR4

®

STICK-ON

APPLICATION: The ST-PBR4 is a mounting

frame with slots for four STICK-ON modules. The
ST-PBR4 mounts on an FP-PSB1A power supply
bracket, to any flat surface or in an FP-RRA or
FP-RRAH rack panel. The ST-PBR4 design
allows the installer to secure the modules without
using any adhesive pads. Each module slides in
and snaps into position. It may be easily released
for adjustment or removal.

Mounting Bracket

Shown with four STICK-ON modules installed

ST-BPR4 mounted on FP-PSB1A power supply bracket.

The FP-PSB1A/ST-PBR4 assembly may be mounted directly to any flat
Surface or may be mounted in an RDL FP-RRA or FP-RRAH rack panel.

RDL • 659 N. 6th St. • Prescott, AZ., USA 86301 • [phone] • FAX [phone] • www.rdlnet.com

ST-PBR4 mounted in an FP-RRA rack mount panel.

ACCESSORIES

Model ST-PBR4
STICK-ON Mounting Bracket

Step 1:

Fasten ST-PBR4 to flat
surface (or to FP-PSB1A
Power Supply Mounting
Bracket, available
separately)

Installation/Operation

EN55103-1 E1-E5; EN55103-2 E1-E4

Typical Performance reflects product at publication time
exclusive of EMC data, if any, supplied with product.
Specifications are subject to change without notice.

Step 2:

Slide STICK-ON
module(s) into the slots
until they latch.

The ST-PBR4 can also be
mounted to any of the
FLAT-PAK mounting
brackets. (FP-RRA shown
sold separately)

STICK-ON modules can easily slide out for removal or adjustment by applying outward pressure to the ST-PBR4 tabs located at
each side of the module.

TYPICAL PERFORMANCE

Dimensions: Height: 2.23 in. 5.67 cm

Width: 3.3 in. 8.38 cm
Length: 5.95 in. 15.1 cm

Radio Design Labs Technical Support Centers

U.S.A. [phone], [phone]; Fax: [phone]

891-2125A

Europe [NH Amsterdam] (++31) 20-6238 983; Fax: (++31) 20-6225-287