RDL SAS-HC8 Quick Start Guide

™

SourceFlex

System

Model SAS-HC8
Headphone Control Listening Station

OR

Install mounting bracket to flat surface using either the screw
holes or slots provided for the mounting screws.

_________________________________________________________________________________________________________

Install bracket to pipe or tubing using the smallest possible clamp provided.
The clamp must be oriented as shown with the “tail” inside the bracket.

Installation/Operation

EN55103-1 E1-E5; EN55103-2 E1-E4

Typical Performance reflects product at publication time
exclusive of EMC data, if any, supplied with product.
Specifications are subject to change without notice.

Remove the lower (larger) cover at the left end of the unit using the two screws shown. Connect the
wires from the S

___________________________________________________________

To operate SAS-HC8: Plug in headphone, select desired source and adjust up/down level
buttons for a comfortable audio level. If headphones are left unplugged 15 seconds, the
volume returns to minimum to protect the next user.

TYPICAL PERFORMANCE

Input: 6-position terminal block
Display: 7-segment red LED (0 = off or Paging; 1 through 8 = selected channel)
Control Buttons: Replaceable, protected by moisture-resistant polycarbonate
Controls: Momentary button channel SELECT
Momentary button volume ramp UP
Momentary button volume ramp DOWN
Ramp Rate: 5 seconds nominal for 40 dB audio level adjustment
Frequency Response: 50 Hz to 35 kHz (+/-1 dB)
THD+N: < 0.1% (20 Hz to 20 kHz) @ 1 kHz
Control Signals: dc (RAMP and CONTROL conductors between remote Listening Station and Controller)
Output Jacks (2): 1/4 in. (6.35 mm) headphone jack or 1/8 in. (mini) headphone jack
Amplified Output: 200 mW RMS into 100 Ohms, adjustable (normal system audio input operating level applied)
Mounting: Bracket with clamps included, mounts to flat surface or to tubing 0.75 in. (1.9 cm) to 1.5 in. (3.8 cm) diameter
Finish: RDL ULTRASTYLE™ design

891-9130

OURCEFLEX controller as indicated in the connection diagram. Secure cover.

Secure the unit in the mounting bracket:

•First, seat the bottom bracket in the
SAS-HC8 bottom rear slot;

•Then tilt the unit back until it snaps and
locks into position.

Radio Design Labs Technical Support Centers

U.S.A. [phone], [phone]; Fax: [phone]

Europe [NH Amsterdam] (++31) 20-6238 983; Fax: (++31) 20-6225-287