ACCESSORIES
Model RU-BR1
Mounting Bracket for RACK-UP Series
The RU-BR1 mounts a RACK-UP module below a horizontal surface.
Front
Front with Product Installed
(RU-SM16D available separately)
RDL • 659 6th St. • Prescott, AZ., USA 86301 • (928) 443-9391 • FAX (928) 443-9392 • www.rdlnet.com
ACCESSORIES
Model RU-BR1
Mounting Bracket for RACK-UP Series
Installation/Operation
Declaration of Conformity available from rdlnet.com.
Sole EMC specications provided on product package.
Specications are subject to change without notice.
STEP #1
Start the screws into the bottom of the RACK UP to be
mounted in the RU-BR1 but do not install them all the way.
STEP #3
Secure the unit to the mounting chassis by sliding the unit
rearward into the RU-BR1 so that the screws seat into the
mounting holes. Tighten the screws.
STEP #2
Secure the RU-BR1 to the desired mounting surface.
(Mounting hardware not provided)
NOTE: When installing a RACK UP product that is in a
plastic box start by removing the screws from the back
of the RACK UP. Bend the tabs on the mounting unit up
at a 90° angle. Secure the unit to the mounting chassis
using the screws.
891-3070A
Radio Design Labs Technical Support Centers
U.S.A. (800) 933-1780, (928) 778-3554; Fax: (928) 778-3506
Europe [NH Amsterdam] (++31) 20-6238 983; Fax: (++31) 20-6225-287
Loading...