RDL PM-1T Installation Guide

ACCESSORIES
screwdriver
.
Model PM-1T Tray Pole Mount for FLAT-PAK®, STICK-ON®, and TX™ products
Installation/Operation
EN55103-1 E1-E5; EN55103-2 E1-E4
Typical Performance reflects product at publication time exclusive of EMC data, if any, supplied with product. Specifications are subject to change without notice.
1. Slide hose
clamp and tray
on the pole.
3. Mount your RDL product.
2. Secure the tray by
tightening the hose clamp to
mounting brackets using a
The PM-1T is designed to mount any RDL FLAT-PAK module to a projector pole. This is a horizontal mounting system designed to grip a standard 1-1/2” I.D. pole common to most projector mounts. An included set of brackets and hose clamp allows mounting to poles smaller than 1-1/2” and to square or rectangular projector mounts. Adequate vertical pole clearance must be available for mounting the PM-1T.
Capacity: 1 PS-24U2 Power Supply, and 1 FP-PA20 (A) (B) module, 2 TX or ST modules Dimensions (each): Height: 2.5” (6.37cm) Depth: 10” (25.4cm) Width: 11.25” (28.57cm) Material: 18-gauge steel Finish: RDL Black
Radio Design Labs Technical Support Centers
U.S.A. (800) 933-1780, (520) 778-3554; Fax: (520) 778-3506
891-5185
Europe [NH Amsterdam] (++31) 20-6238 983; Fax: (++31) 20-6225-287
Loading...