RDL FP-AVDA4 Quick Start Guide

FLAT-PAK™ SERIES

Model FP-AVDA4
Audio/Video Distribution Amplifier

2A MAX

INPUT

VIDEO

POWER

24 VDC

INPUT

LEFT AUDIO

RIGHT AUDIO

OUTPUT 2OUTPUT 1

Stereo Audio/Video

Outputs Feeding Other

Stereo Audio/Video

OUTPUT 3 OUTPUT 4INPUT

Equipment

OR

24 VDC

POWER

SOURCE

1A MAX

Stereo Audio/Video

Source Feeding
FP-AVDA4 Input

TYPICAL PERFORMANCE

VIDEO SECTION:
Input: Phono jack, 1V p-p
Input Impedance: 75 Ω
Gain: Unity
Load Impedance: 75 Ω
Outputs (4): Phono jack
Output Level: 1 V p-p (into 75 Ω)
Frequency Response: 10 Hz - 10 MHz (+/- 0.2 dB)
Noise: < -75 dB (below 1 V p-p)
Output Isolation: > 45 dB
Differential Gain: 0.1%
Differential Phase: 0.1 degree (measured at 10% and 90% APL)
AUDIO SECTION:

Inputs (2): Phono jacks (stereo), -10 dBV Unbalanced
Input impedance: 10 kΩ, bridging
Gain: Unity
Outputs (8): Phono jacks (4 stereo)
Output impedance: 150 Ω, drives 10 kΩ lines
Frequency Response: 20 Hz to 40 kHz (+/- 0.25 dB)
THD+N: < 0.05%; typ. 0.01% (1 kHz)
IMD: < 0.02%
Output Level: -10 dBV
Headroom: > 18 dB
Noise: < -85 dB referred to –10 dBV (20 Hz to 20 kHz)
Crosstalk: Better than -75 dB (20 Hz to 20 kHz); typ <-90 dB (1 kHz)

Power Requirement: 24 Vdc @ 60 mA, Ground-referenced
Dimensions:
Height: 0.88 in. 2.24 cm (not including connectors)
Height: 1.35 in. 3.43 cm (including connectors)
Width: 3.25 in. 8.26 cm
Length: 6.40 in. 16.26 cm

Installation Instructions

Typical Performance reflects product at
publication time exclusive of EMC data, if any,
supplied with product.

70 mA

CURRENT

FP-AVDA4

PWR BUS OUT

Power to Additional

Flat-Pak Modules, Total

Current Not to Exceed 2 A

or Available Supply Current

891-2010

Radio Design Labs Customer Service Centers

U.S.A. [phone], [phone]; Fax: [phone]