RDL DRA-35R Datasheet

ACCESSORIES

Model DRA-35R

RACK-UP DIN Rail Adapter

The DRA-35R provides DIN rail mounting for any RDL RACK-UP® module, allowing full access to the front and
rear panels of the mounted modules. The DRA-35R attaches to a 35 mm DIN Rail.

Front

Rear

With Product Installed
(Available Separately)

RDL • 659 6th St. • Prescott, AZ., USA 86301 • [phone] • FAX [phone] • www.rdlnet.com

ACCESSORIES

Model DRA-35R

RACK-UP DIN Rail Adapter

Installation/Operation

Declaration of Conformity available from rdlnet.com.

Sole EMC specications provided on product package.
Specications are subject to change without notice.

STEP #1
Attach the DRA-35R to the DIN rail with the included
screws.

(Bottom View)

STEP #3
Secure the RACK-UP to the DRA-35R chassis by sliding the
unit rearward so that the screws seat into the mounting
holes and tighten the screws.

STEP #2
Start the screws into the bottom of the RACK-UP but do not
install them all the way.

If desired use the rectangular cut outs in the chassis to secure
wiring with hook and loop fastener or wire-ties. The smaller
holes can be used for ground wire attachment.

891-5174A

NOTE: When installing a RACK UP product that is in a
plastic box start by removing the screws from the back
of the RACK UP. Bend the tabs on the mounting unit up
at a 90° angle. Secure the unit to the mounting chassis
using the screws.

Radio Design Labs Technical Support Centers

U.S.A. [phone], [phone]; Fax: [phone]

Europe [NH Amsterdam] (++31) 20-6238 983; Fax: (++31) 20-6225-287