RCS REFR2 Owner's Manual

- 1 - | Page
Renaissance Cooking Systems
REFR2
Owner’s Manual
RCS Indoor & Outdoor Electric Refrigerator
PLEASE READ THE MANUAL THORO UG HLY PRIOR TO
EQUIPMENT SET-UP, OPERATION AND MAINTENANCE .
This owner’s manual was updated January 2016
www.RCSGasGrills.com
SAVE THESE IN STRUCTIONS
- 2 - | Page
INSTALLATION
IMPORTANT!!! PLEASE READ BEFORE INSTALLATION
If the unit has recently been transportedplease let unit stand upright for a minimum of 24 hours before plugging it in.
Make sure that the unit drops down to desired temperature before loading the unit with product.
Make sure that there is proper ventilation around the unit in the area where it will operate.
Make sure all accessories are installed (i.e. shelves, shelf clips) before plugging the unit in.
Please read through the manual in its entirety.
CABINET LOCATION GUIDELINES
Install the unit on strong and leveled surfaces
-unit may make unpleasant noises if surface is uneven
-unit may malfunction if surface is uneven
Insta ll the unit in a dry, well-ventilated area
-unit should be away from direct sunlight, Extreme cold ambient
temperatures may also cause the unit not to perform properly.
Avoid installation in a high humidity and/or dusty area
-humidity could cause unit to rust and decrease efficiency or malfunction
-dust collected on condenser coil will cause unit to decrease efficiency or
malfunction. Clean the condenser coil at least once a month with a brush or clean cloth
For optimal energy consumption, it is suggested to keep 20” distance from heat emitting devices (ex: cooking appliances, radiators, water heaters, or similar devices) and moisture-generating equipment
-high ambient tem peratures w ill cause t he co mpressor to overwork, leading
to higher energy bills and gradual breakdown of the unit
For proper ventilation, please leave 6" of space at each side of the unit inside of the countertop, and please be sure that the underside of the unit is left unobstructed. And there should be air vent opened to the outside of the island
- 4 - | Page
INSTALLING THE GLASS SHELF
Open the door. The glass shelf is packed underneath the Refrigerator Basket.
Take the glass shelf out of the refrigerator and packaging.
Put the glass shelf onto the Protective Pads.
CHANGING THE DOOR’S SWING
The direction of the door opens could be changed by placing the Upper and Lower Hinges in different corners. Remove the hardware on the Control Panel and Hinges as shown. Place the hinges and door to your preference. Reinstall the Control Panel and Hardware. Each unit comes with a top Left-handed hinge.
Loading...
+ 6 hidden pages