RC LEADING TOYS FACTORY CR101 User Manual

Instruction sheet of TF card reader
This product is used for micro SD card read and write data, products adopt single chip technology, and support the USB2.0 interface, reading and writing data with quick speed, stable, safety and reliable, which can be widely used in various non life safety industries
The products produced under the environmental in strict accordance with protection process production, confirm to EU environmental protection and the FCC safety requirements.
size47*19.3*9.5mmVoltage: 5V ±0.5 VWorking Current ≤70mA Working temperature -10~+70℃ ⑤The interface type USB2.0 without driving(it can be work when plug it) ⑥Support systemWindowsLinux
FCC Statement:
FCC ID:2AGR2-CR101
This equipment has been tested and found to comply with the limits for Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment to an outlet on a circuit different from that to
which the receiver is connected. This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Loading...