RCF MZ-8060 Data Sheet
MZ 8060
AUDIO MATRIX
DESCRIPTION
MZ 8060 is a highly versatile digital audio
matrix designed on a powerful DSP platform,
based on advanced electronics. It features a
8x6 matrix, where 8 universal MIC-LINE inputs
and 6 outputs can be processed through a
large number of audio parameters, such as
parametric equalizers, compressors, gates,
limiters, delays, duckers, priorities, automixer. The Automatic Level Control facility is
also available, a probe can be connected on
input 8, in order to automatically adjust the
volume level according to the environmental
noise measured. MZ 8060 is able to receive 10
logic inputs (GPI) and send 6 logic outputs
(GPO), assignable. 2 of these outputs are
operated by a relay. A serial port can be set to
control the unit from a third party system
(e.g. Crestron and AMX). Moreover, it is
possible to link two MZ 8060 (in master-slave
configuration) to create a 16-input 12-output
matrix.
A slot on the rear panel allows the integration
of an optional RCF RDNet module, to access
MZ 8060 through an RDNet control network.
Up to 12 paging consoles BM 3003 can be
daisy-chained to the dedicated RJ 45 input,
alternative on input 1. The front panel
FEATURES
• 40-bit floating point processing DSP and 48 kHz 24-bit HI-Q Analogue/Digital Conversion, dynamic
range > 112 dB.
• 8 universal inputs (48V), 6 outputs - 4 Euroblocks bal., 2 RCA plugs
• 10 programmable logic inputs (GPI), 6 programmable logic outputs (GPO), 2 of which supported by
relay.
• Configurable parametric EQs, gates, compressors, limiters, delays, priority levels, automatic gain
control, levels, gains on in-out and cross points, auto-mixer operations, filters
• Each unit can work as dual-room combiner with independent auto-mixer facility for each room
• Configurable ALC (Automatic Level Control) facility by using Input 8 to connect a noise detection
microphone. The control is then assignable to any output or group of outputs
• USB connectivity for device configuration
• RDNet Networked Control
DATASHEET
TECHNICAL SPECIFICATIONS
Audio performance
Frequency Response (-3dB):
20 Hz ÷ 20 kHz
Distortion (THD+N) @ 1 kHz nominal
power:
<0.01 %%
Dynamic range:
>114 dB
Digital audio performance
Sampling rate:
48
A/D - D/A converters:
24
Input section
Total number of inputs:
9
Balanced:
9
Mono:
9
Mic+Line inputs:
8
Mic+Line connectors:
Euroblock, RCA
Mic+Line Phantom:
48 V DC
Paging inputs:
1
Paging connectors:
RJ45
Paging command:
Contact
Output section
Signal output number:
6
Signal output connectors:
Euroblock, RCA
General Purpose Outputs (GPO):
10
Programmable GPO:
Yes
Processing
DSP:
Yes
EQ Filters:
Yes
Compressors:
Yes
Automatic Gain Control (ACG):
Yes
Controls
Configuration:
PC Software
Number of programs/presets:
16
Priority:
Yes
Protocols for system integration:
ASCII
Protections
Cooling:
Convection
Fuses:
Yes
Power requirement
Operating voltage:
90-240 V~ 50/60HzV ~ Hz
Power consumption:
60 W
Standard compliance
CE marking:
Yes
Physical specifications
Cabinet/Case Material:
Metal
Rack mounting:
19", 1U
DATASHEET
RCF products are continually improved. All specifications are therefore subject to change without notice.
Loading...