Circuitry used in some versions.
Ground
Chassis ground
Common tie point
Taken from common tie point
3
Schematic voltage source tie point.
Cabling: Heavy lines reduce use of multiple lines.
A
Waveforms and voltages are taken from ground, unless
noted otherwise.
Waveforms taken with triggered scope and keyed rainbow
generator. Waveform voltage is peak to peak. Timebase
is per division. Waveforms shown at 10 divisions.
Supply voltages maintained as seen at input.
Voltages measured with digital meter and a 1000µV RF
signal, with colorbar pattern, applied to antenna terminal.
Controls adjusted for normal operation.
Capacitors are 50 volts or less, 5% or greater unless noted.
Electrolytic capacitors are 50 volts or less,
20% or greater unless noted.
Resistors are 1/2W or less, 5% or greater unless noted.
Value in ( ) used in some versions.
Measurements with switching as shown, unless noted.
Rated voltage shown on zener diodes.
# For SAFETY use only equivalent replacement part.
(1) Focus and screen controls are part of T4401.
(2) Yoke is bonded part of CRT assembly.
PARTS LIST continued
MISCELLANEOUS
Item No.DescriptionMfr. Part No.Notes
CF1201Filter1957024.5MHz
CF2301Filter1811254.5MHz
# F4001Fuse1754255Amp, 125V, Fast Acting
IR3402Receiver237682Remote
J101Jack215543RF
# K4201
# KS5001
# PW4001
SF2301Filter217318SAW
SP1902Speaker2334422 1/4" X 3 1/2", 32 Ohms, 1.5W
SW3410Switch215500Channel Up
SW3411Switch215500Power
SW3420Switch215500Channel Down
SW3421Switch215500Volume Up
SW3430Switch215500Menu
SW3431Switch215500Volume Down