rba RBA8851-137-PP, RBA8851-137-SS Installation, Operation And Maintenance Instructions

Page 1
INSTALLATION, OPERATION AND MAINTENANCE INSTRUCTIONS
SYDNEY | MELBOURNE | BRISBANE | PERTH | AUCKLAND
Australia 1300 788 778 www.rba.com.au | New Zealand 0800 722 111 www.rbagroup.co.nz
Bariatric Toilet RBA8851-137-PP RBA8851-137-SS
Date
28/09/17
Model
Bariatric Toilet
Supercedes all previous
Lic. # WMKA-00291
Page 2
INSTALLATION, OPERATION AND MAINTENANCE INSTRUCTIONS
SYDNEY | MELBOURNE | BRISBANE | PERTH | AUCKLAND
Australia 1300 788 778 www.rba.com.au | New Zealand 0800 722 111 www.rbagroup.co.nz
Components
“P” Trap Stainless Steel Pan “S” Trap converter Security bit
Pre-installation
Installation should be in accordance with local authority and statutory requirements, and as per these installation instructions.
Pan is “wall faced” and should preferably be xed to a masonry wall with suitable wall anchors provided by others. Supplied with “S” trap converter to allow either “S” or “P” conguration.
Flushing device should be – Fowler Tasman Mk 2 (or Stylus Symphony) cistern Caroma Invisi II (Inceiling mount recommended) Sloan Dual Flush Valve
Installation
1. If not pre-formed, make sufcient penetrations through the wall, as determined from the drawing, to allow the 100 mm waste pipe, 50 mm ush pipe, and, if necessary, 12 mm xing rods to pass through. If front xed, suitable wall anchors supplied by others.
2. Determine oor mounting location by mocking up.
3. Fit a 100 mm pan collar to the outlet with sufcient 100 mm pipe to extend through the wall. (Alternately the waste and ush pipes may be preplumbed and the pan pushed onto the pipework.) If “S” trap conguration is required, location of oor penetration should be centred 220mm from nished wall.
4. Similarly t a 50 mm keeseal to the pan inlet with sufcient pipe, as provided by the cistern manufacturer, to extend through the wall.
5. Push the pan into position and secure the pan to the wall & oor (xings by others).
6. Make the necessary connections to the waste, and install the cistern and connect according to the manufacturers instructions.
7. Check for leaks and correct ush volumes, 6 litres full ush and 3 litres half ush.
Page 3
INSTALLATION, OPERATION AND MAINTENANCE INSTRUCTIONS
SYDNEY | MELBOURNE | BRISBANE | PERTH | AUCKLAND
Australia 1300 788 778 www.rba.com.au | New Zealand 0800 722 111 www.rbagroup.co.nz
Installation
Front Fixed Shown
1 Access Panels 2 Optional - RBA8186-853 Big John
Hinged Seat Rated 545kg 3 55mm ID Flushing Inlet:
Keyseal (By Others) 4 Wall Anchors and
Anchoring Hardware (By Others) 5 100mm OD Waste Outlet
6 Mounting Slots Ø15mm x 38mm
View From Rear of Fixture
6
Page 4
INSTALLATION, OPERATION AND MAINTENANCE INSTRUCTIONS
SYDNEY | MELBOURNE | BRISBANE | PERTH | AUCKLAND
Australia 1300 788 778 www.rba.com.au | New Zealand 0800 722 111 www.rbagroup.co.nz
Warning
Do not mix different cleaning solutions. Always read cleaning products label for proper use and admonishments.
Recommended Cleaning Materials:
• Sponge - natural or articial
• Nylon or other soft-bristle brush
• Microber Cloth
Recommended Cleaning Solutions:
• Hand dishwashing liquid / soft water solution
• Mild soap / soft water solution
• Soft-Scrub ®
• Comet Soft Cleanser ®
• Clorox ®
• Scrubbing Bubbles ® Gel
Normal Cleaning:
For everyday cleaning use a sponge or cotton cloth soaked in mild soap and wipe-down surface. In industrial or marine locations close attention should be paid to regular care due to harsher atmosphere.
To remove dirt and debris:
Fixture should be periodically washed with a diluted solution of a mild non-abrasive detergent (e.g. Dawn ®) in cold or ambient temperature water using a soft non- abrasive cloth or chamois.
Toilet Fixtures with Enviro-Glaze/ Powder Coating
Never use a plumber’s snake to clear severe clogs. The use of the tool will damage the nish, scratch the paint and cause corrosion voiding the warranty. Fixture must be dismounted from the structure sewer connection (oor/wall) and the snake used from the connection into the sewer. Any clog in the xture trap can be accessed from the outlet of the trap after dismounting.
Cleaning Solutions NOT to be used:
• Kaboom ®
• Lysol ® Gel
• Lysol ® Cling
• The Works
• Petrol products
• Acetates
• Abrasive powders
• Scouring pads
• Toilet cleaners
• Ceramic tile cleaners
• Cleaners containing more than 1% ammonia
• Cleaners containing acids or lye
• Cleaners containing enzymes
Things to Avoid:
• Excessively hot solutions
• Cleaning with a metal brush can scratch or mark the nish which can cause corrosion voiding the warranty
• Using any solvent based solution or abrasive type cleaners
• Applying excessive force during the cleaning process
Cleaning & Care
Loading...