Razor XLR8R User Manual

IMPORTANT NOTICES

The Razor electric scooter must reach a speed of three miles per hour before the motor

will engage.

Ride only on smooth hard and dry surfaces. The Razor was not intended for off-road or

hilly terrain. Use caution when approaching curbs, uneven pavement, potholes or similar conditions. Avoid water. The tires are extremely slippery when wet. You could lose traction and fall.

The Razor is designed for only one rider. Do not attempt to ride with more than one person

or attempt to tow anything behind your scooter.

Not recommended for children under 16 without adult supervision.

Maximum weight capacity on flat and level ground: 120 pounds.

WARNING: Intermittent motor operation is an indication of low charge. When this occurs,

turn the unit off and charge the battery

Be sure to read and understand this manual thoroughly before operating your scooter. Additional warnings enclosed.

To obtain service under this warranty you must, within the warranty period, contact Razor USA LLC directly by e-mail at warranty@ razorusa.com. Razor will provide repair parts and or replacement at its sole discretion. Authorized warranty service is ONLY available from Razor USA LLC or its authorized Repair Center(s).

Owner’s Manual

+ Safety Handbook

The Razor electric scooter must reach a

speed of 3 miles per hour before the motor

will engage.

Specifications subject to change without notice.

Photos by Arthur Cambridge.

Razor USA LLC

Cerritos, California 90703

www.razor.com

Read and understand this manual prior to use

Make sure the XLR8R battery is fully charged. DO NOT CHARGE FOR MORE THAN 15 HOURS.

Make sure the XLR8R is properly installed. (See the Attaching the XLR8R Motor to Your Scooter section in this manual).

Make sure the scooter is in good working condition and the rearwheel brake is functional.

Use only in accordance with local laws. Never exceed the maximum weight of 120 pounds on a XLR8R-

powered scooter. Never let more than one child at a time on a XLR8R-powered

scooter. Never tow anything with a XLR8R-powered scooter. Never apply pressure to the rear brake while the XLR8R motor is

engaged. DO NOT use an XLR8R-powered scooter in wet, snowy, or icy

conditions. Avoid spraying the XLR8R Motor with water to clean it. Moisture

inside the XLR8R case could cause electrical shorts and/or corrosion to electrical components.

KEEP WHEELS FRESH, IF WORN OUT, REPLACE IMMEDIATELY.

Worn wheels directly affect the performance of your drive system.

Attaching the XLR8R Motor to Your Scooter

Attaching the XLR8R Motor to your scooter involves two steps: (1) installing the Mounting Bracket and (2) attaching the XLR8R Motor to the Mounting bracket.

Installing the Mounting Bracket To install the Mounting Bracket, Use only with Scooters without

shocks or suspension springs.

1. Slip the Mounting Bracket's fork slot onto the front of the scooter's fork

Note: If your scooter has a strap ring on the leading edge of its front fork, you should be able to see the ring through the small window in the mounting bracket

Aligning the fork to the bracket

2. Using the screws and plate provided, securely fasten the Mounting Bracket to the scooter's steering tube. Note that it is helpful to alternately tighten each screw a little at a time so that the plate is square with the bracket.

Installing the screws and tightening the clamps.

Attaching the XLR8R Motor

To attach the XLR8R Motor to the Mounting bracket,

1. Grasp the scooter's handle with one hand and the XLR8R's handle in the other hand, and place one foot on the scooter's deck.

+ 4 hidden pages