Razor RipStik Electric Instruction manual

Razor RipStik Electric

Problem

Possible Cause

Solution

-Does not work out of
the box

-Product must be travelling
at least 3 mph (5 km/h)
before motor will engage

-Product not paired with
remote

-Kick start to at least 3 mph (5 km/h) while
the lever on the remote is in the “GO”
position to engage motor.

-Refer to page 4-5 for pairing information

-No longer works

-No lights on charger

-Undercharged battery

-Battery will not hold a
charge

-Check power to wall outlet and/or try a
different outlet.

-Check lights on charger:
Plugged into wall - Green
Plugged into wall & unit - Red (charging)
Plugged into wall & unit - Green (charging
complete)
No lights/Blinking lights - Replace Charger

-Turn product over. Turn the power switch
on the remote and product to the ON
position. Move the lever on the remote to
the GO position and hold. Manually (use
caution) spin the rear wheel forward. If
motor engages - replace battery

-Short run time/runs
slow

-Riders weight

-Riding conditions

-Battery not fully charged

-Old/damaged battery

-Do not exceed 143 lb (65 kg) maximum
weight limit.

-Use only on flat, dry surfaces. Avoid
inclines and areas with heavy debris.

-Charge product - refer to page 6 for
charging information.
Replace battery.

-Charge battery at least once a month
when not in use.