Razor Ground Force User Manual
Tools Required: (Not included)
A. 4mm Allen wrench
B. 5mm Allen wrench
WARNING
GROUND FORCE® GO KART (V.1+)
BATTERY INSTALLATION INSTRUCTIONS
Do not use non-Razor products with your Razor electric
scooter. The scooter has been built to certain Razor
design specifications.Certain aftermarket parts may or
may not be compatible.
As with all consumer electronics, use of compatible
batteries and chargers is strongly recommended. Failure
to do so may pose a fire hazard.
Examine the battery, charger and their connectors for
excessive wear or damage each time you charge the
battery. If damage or excessive wear is detected, do not
use the charger or the vehicle until you have replaced
the worn or damaged part.
Battery connectors may contain lead and lead
compounds. Wash your hands after handling.
CAUTION: To avoid potential shock or other injury, turn power switch OFF and disconnect charger before removing or installing the batteries. Failure to follow these steps in the
correct order may cause irreparable damage.
Step 1
Using a 5mm Allen wrench, remove the four hex
bolts on the battery cover and remove.
Step 2
Cut the zip tie holding the wires to the battery
bracket. Using a 4mm Allen wrench, loosen
the two bolts on the battery bracket and remove from battery.
Figure 1 Figure 2
Need Help? Visit our website at www.razor.com or call toll-free at 866-467-2967 Monday - Friday 8:00am - 5:00pm Pacific Time.
1
Step 3 Step 4
Locate the white plastic connector on the battery.
Cut the zip tie and discard it. Disconnect the white
plastic connectors attached to the battery and
Carefully lift the batteries out of the battery tray,
one battery at a time. See page 3 for battery care
and disposal information.
control module by depressing the tab.
Figure 3 Figure 4
Step 5
1. Place new battery into the battery tray.
2. Reconnect the battery connector to the connector on the control module.
3. Reattach battery bracket to secure the battery in place.
4. Reattach battery cover using the four screws and locknuts previously removed.
ATTENTION: Charge unit at least 18 hours before riding.
Need Help? Visit our website at www.razor.com or call toll-free at 866-467-2967 Monday - Friday 8:00am - 5:00pm Pacific Time.
2
Loading...