Razor 15130640 User Manual

OWNER’S MANUAL
WARNING:
can eliminate. If such things occur you can be seriously injured or die, even
when using safety equipment and other precautions. RIDE AT YOUR OWN
This manual contains many warnings and cautions concerning the
consequences of failing to maintain, inspect or properly use your Pocket
APPROPRIATE RIDER USE AND
This manual contains important safety information. It is your responsibility
to review this information and make sure that all riders understand all
warnings, cautions, instructions and safety topics and assure that young
that you periodically review and reinforce the information in this manual with
younger riders, and that you inspect and maintain your children’s vehicle to
The recommended rider age of 12 and older for Pocket Mod is only an
comfortable and competent while operating the vehicle.
very hot.
ACCEPTABLE RIDING PRACTICES AND
Always check and obey any local laws or regulations which may affect the
traffi c hazards and not on public streets or sidewalks. Do not ride your
wheel or force you to swerve suddenly or lose control. Be careful to avoid
any other type of stunts.
The Pocket Mod is intended for use on solid, fl at, clean and dry surfaces such
as pavement or level ground without loose debris such as rocks or gravel.
Wet, slick or uneven and rough surfaces may impair traction and contribute
to possible accidents. Do not drive the Pocket Mod in mud, ice, puddles or
water. Avoid excessive speeds that can be associated with downhill rides.
Always wear proper protective equipment such as an approved safety
and drive system.
The charger supplied with the Pocket Mod should be regularly examined for
The charger is not a toy.
Always disconnect from the charger prior to wiping down and cleaning your
ABOVE WARNINGS INCREASES RISK OF SERIOUS
SAFETY WARNINGS
Assembly and Set-Up
....................................................
3
4-6
Troubleshooting Guide
........................................................
Warranty
CONTENTS
Allow up to 15 minutes for assembly, not including initial charge time.
Allow up to 12 hours for initial charge (see page 3 for charging information).
BEFORE YOU BEGIN
WARNING:
The Pocket Mod has been built to
certain Razor design specifi cations.
The original equipment supplied at
the time of sale was selected on
the basis of its compatibility with
the frame, fork and all other parts.
as a last resort.
Visit our web site for updates and a list of authorized service centers at
www.razor.com
866-467-2967
key wrench
(included)
for Schrader valve tires,
with pressure gauge
Adjuster
Tire
Wheel
WARNING:
The brake
throwing an unsuspecting rider.
the brake function. Avoid skidding
to a stop as this can cause you to
The brake lever contains a
when the brake is applied. In an
will always stop the motor. Do not
disable or replace this lever with
anything other than a genuine Razor
3
ASSEMBLY AND SET-UP
through front fairing and into
fork.
Tighten down the hexagonal
wrench.
Attaching the Handlebars
Your Pocket Mod may not have a fully charged battery; therefore it is a good idea to charge the battery prior to use.
depending on the level of depletion
the port on the Pocket Mod. The
charger works with the power
WARNING:
Always
disconnect your Pocket Mod from
the charger before cleaning with
your unit has been supplied
with an alternative charger.
The specifi cations and charging
The charger has a small window
with one LED or two LEDs to
to the illustration on the charger
your model charger.
socket on the case; otherwise,
WARNING:
Failing to
clamps and retainers that affi x the
control and fall.
Testing the Brakes
To use the brake, squeeze the lever to increase the pressure on the brake. The brake lever is fi tted with a cable adjuster
to compensate for cable stretch and/or to fi ne-tune the lever movement to brake engagement. If brake is not engaging
Loading...
+ 9 hidden pages