CONTENTS
Safety Warnings ............................................................ 1
Before You Begin ........................................................... 2
Assembly and Set-Up ................................................. 3-4
Repair and Maintenance ............................................. 4-6
SAFETY WARNINGS
WARNING: Riding the Sport Mod can be a hazardous activity.
Certain conditions may cause the equipment to fail without fault of the
manufacturer. Like other electric vehicles, the Sport Mod can and is intended
to move, and it is therefore possible to lose control, fall off and/or get into
dangerous situations that no amount of care, instruction or expertise can
eliminate. If such things occur you can be seriously injured or die, even when
using safety equipment and other precautions. RIDE AT YOUR OWN RISK
AND USE COMMON SENSE.
This manual contains many warnings and cautions concerning the
consequences of failing to maintain, inspect or properly use your Sport Mod.
Because any incident can result in serious injury or even death, we do not
repeat the warning of potential serious injury or death each time such a
possibility is mentioned.
APPROPRIATE RIDER USE AND
PARENTAL SUPERVISION
This manual contains important safety information. It is your responsibility
to review this information and make sure that all riders understand all
warnings, cautions, instructions and safety topics and assure that young
riders are able to safely and responsibly use this product. Razor recommends
that you periodically review and reinforce the information in this manual with
younger riders, and that you inspect and maintain your children’s vehicle to
insure their safety.
The recommended rider age of 12 and older for Sport Mod is only an
estimate, and can be affected by the rider’s size, weight or skills. Any rider
unable to fit comfortably on the Sport Mod should not attempt to ride it. A
parent’s decision to allow his or her child to ride this product should
be based on the child’s maturity, skill and ability to follow rules.
Keep this product away from small children and remember that this product
is intended for use only by persons who are, at a minimum, completely
comfortable and competent while operating the vehicle.
DO NOT EXCEED THE WEIGHT LIMIT OF 220 pounds.
Rider weight does not necessarily mean a person’s size is appropriate to fit
or maintain control of the Sport Mod.
Do not touch the motor on your Sport Mod when in use as it can become
very hot.
Refer to the section on safety for additional warnings.
ACCEPTABLE RIDING PRACTICES AND
CONDITIONS
Always check and obey any local laws or regulations which may affect the
locations where the Sport Mod may be used on public property. The Sport
Mod is meant to be used only in controlled environments free of potential
traffic hazards and not on public streets or sidewalks. Do not ride your
Sport Mod in any areas where pedestrian or vehicle traffic is present.
Troubleshooting Guide ................................................ 7-8
Sport Mod Parts ....................................................... 9-10
Safety Reminders ........................................................ 12
Warranty ...................................................................... 12
Maintain a hold on the handlebars at all times.
Never carry passengers or allow more than one person at a time to ride the
Sport Mod.
Never use near steps or swimming pools.
Keep your fingers and other body parts away from the drive chain, steering
system, wheels and all other moving components.
Never use headphones or a cell phone when riding.
Never hitch a ride with another vehicle.
Do not ride the Sport Mod in wet weather and never immerse the Sport Mod
in water, as the electrical and drive components could be damaged
by water or create other possibly unsafe conditions.
The Sport Mod is intended for use on solid, flat, clean and dry surfaces such
as pavement or level ground without loose debris such as rocks or gravel.
Wet, slick or uneven and rough surfaces may impair traction and contribute
to possible accidents. Do not drive the Sport Mod in mud, ice, puddles or
water. Avoid excessive speeds that can be associated with downhill rides.
Never risk damaging surfaces such as carpet or flooring by use of a Sport
Mod indoors.
Do not ride at night or when visibility is impaired.
PROPER RIDING ATTIRE
Always wear proper protective equipment such as an approved safety
helmet, elbow pads and kneepads. A helmet may be legally required by local
law or regulation in your area. Always wear shoes, never drive barefooted or
in sandals, and keep shoelaces tied and out of the way of the wheels, motor
and drive system.
USING THE CHARGER
The charger supplied with the Sport Mod should be regularly examined for
damage to the cord, plug, enclosure and other parts, and in the event of such
damage, the bike must not be charged until the charger has been repaired or
replaced.
Use only with the recommended charger.
The charger is not a toy.
Always disconnect from the charger prior to wiping down and cleaning your
Sport Mod with liquid.
FAILURE TO USE COMMON SENSE AND HEED THE
ABOVE WARNINGS INCREASES RISK OF SERIOUS
INJURY. USE WITH APPROPRIATE CAUTION AND
SERIOUS ATTENTION TO SAFE OPERATION.
Ride defensively. Watch out for potential obstacles that could catch your
wheel or force you to swerve suddenly or lose control. Be careful to avoid
pedestrians, skaters, skateboards, scooters, bikes, children or animals who
may enter your path, and respect the rights and property of others.
Do not attempt or do stunts or tricks on your Sport Mod. The Sport Mod is
not made to withstand abuse from misuse such as jumping, curb grinding or
any other type of stunts.
1
BEFORE YOU BEGIN
Remove contents from box. Remove the foam separators that protect the components from damage during shipping.
Inspect the contents of the box for scratches in the paint, dents or kinked cables that may have occurred during
shipping. Because the Sport Mod was 95 percent assembled and packed at the factory, there should not be any
problems, even if the box has a few scars or dents.
q Estimated Assembly and Set-Up Time
Razor recommends assembly by an adult with experience in bicycle mechanics.
Allow up to 15 minutes for assembly, not including initial charge time.
Allow up to 12 hours for initial charge (see page 3 for charging information).
Speed Control
Brake Lever
Brake Lever
Adjuster
On/Off
Switch
Tire
Charger
Charger
Port
Charger
Plug
WARNING: DO
NOT USE NON-RAZOR
PRODUCTS WITH YOUR
RAZOR SPORT MOD.
The Sport Mod has been built to
certain Razor design specifications.
The original equipment supplied at
the time of sale was selected on
the basis of its compatibility with
the frame, fork and all other parts.
Certain aftermarket products may
or may not be compatible.
Front Fork
Front Wheel
Charger
Port
Fuse Box
Battery
Kick Stand
Chain Guard
q Required Tools
Some tools may be supplied; however, we recommend the use of mechanic’s grade tools. Use the supplied tools only
as a last resort.
3mm and 6mm
hexagonal key wrenches
(included)
8mm, 10mm and 17mm
wrenches
Phillips screwdriver
Bicycle-style tire pump
for Schrader valve tires,
with pressure gauge
Need Help? Visit our web site for updates and a list of authorized service centers at www.razor.com
or call toll-free at 866-467-2967 Monday - Friday 8:00 AM - 5:00 PM Pacific Time.
2
ASSEMBLY AND SET-UP
q Charging the Battery
Your Sport Mod may not have a fully charged battery; therefore you must charge the battery prior to use.
• Initial charge time: 12 hours • Run time: up to 40 minutes
• Recharge time: up to 8 hours • Average battery life: 250 charge/discharge cycles
• Fully charge once a month when not in use • Do not store below 32 degrees - this can damage the battery.
Charger
Port
Charger
Plug
1 Plug the charger port into the
port on the Sport Mod. The charger
works with the power switch in
either the on or off position.
2 Plug the charger plug into a wall
outlet.
q Attaching the Handlebars
WARNING:
Rechargeable batteries are only to
be charged under adult supervision.
Always disconnect your Sport Mod
from the charger before cleaning
with liquid.
Note: If your charger does not
look like the one illustrated,
your unit has been supplied
with an alternative charger.
The specifications and charging
procedure would not change.
The charger has a small window
with one LED or two LEDs to
indicate the charge status. Refer
to the illustration on the charger
unit for the actual “charging” and
“charged” status indications for
your model charger.
Chargers have built-in over-charge
protection to prevent battery from
being over-charged.
Be sure to properly align the
groove on the charger input
plug with the corresponding
socket on the case; otherwise,
no charging action will occur.
1 Loosen the two hexagonal
bolts with the 3mm hexagonal
wrench and remove the plastic
handlebar cover.
4 Put the plastic handlebar
cover back in place.
2 Insert handlebar assembly into
the fork until it stops. Raise to
desired height, keeping the stem
and fairing aligned within the red
arrows of the safety zone.
5 Secure the two hexagonal bolts
with the 3mm hexagonal wrench.
WARNING: Failing to
properly adjust and tighten the
clamps and retainers that affix the
handlebar can cause you to lose
control and fall.
3 Tighten down the hexagonal
bolt with the 6mm hexagonal
wrench.
3