Raytec Raymax 25 PoE series Installation Manual

Installation Steps

1. Mount Illuminator

2. Connect Power

Set Up Steps

1. Optional night set-up for optimum
image performance

2. Adjust vertical angle

3. Tighten all fixings

Package Contents

1. Illuminator with Integrated PSU

illuminators installation guide

MAX 25 PoE

This installation guide provides instructions for installing the RAYMAX 25 PoE
series illuminators.

Version 6.0

Overview

RAYMAX 25 PoE illuminator

Integrated PSU

(back of illuminator)

2

!

Install in a well
ventilated area

Specifications subject to change without notice. Installation to be carried out by suitable trained and qualified personnel.

LED illuminator

Standard U Bracket

Do not continually

stare at lamp

1.5 m

Install

internally only

PoE

Power
adjust

P-cell
adjust

Power On

Power Indicator

Telemetry Control

- telemetry input
requires zero volt
latched input, non
polarity sensitive

PoE Input

12V DC
24V AC/DC

(Optional input

instead of PoE)

3

Installation

1

Mount illuminator

Connect Power

2

1

2

Set Up

1

Optional night set-up
for optimum image
performance

TARGET

Tighten all fixings

2 3

Adjust vertical angle

Match illumination to camera field of view

Camera

Light

Light

x x

Light

Camera

Reduces performance May cause hot spots Best performance

Camera

INTERNAL USE ONLY

!

Use wall bracket if you require horizontal adjustment.

4

Technical Drawings (Not to scale)

Optional Bracketry

Wall Mount

Standard Bracketry

RM 25 PoE

Specifications

INFRA-RED Series

Input Output PoE Photocell

Adjustable

Power

Weight

Dimensions

L x W x D

PoE or

12V DC

24AC/DC

12W

IEEE802.3af
Compliant Interface
Power classification

(class 0)

CAT5 Cable

Integrated

(adjustable

sensitivity)

10% - 100%

0.8kg

(1.8lbs)

75 x 100 x 54mm

3” x 4” x 2”

(approx)

Command and Control
Integrated Power Supply Features

• Adjustable photocell

• Adjustable power

• Telemetry input

8.5mm
(0.3”)

25mm

(1”)

23.5mm
(0.9”)

47mm

(1.9”)

48mm

(1.9”)

5

Trouble Shooting

Step 1: Basics

Check blue LED ‘power on’ light is illuminated on the back of the PoE unit.

If Ye s ,

• Ensure power adjust is turned to the maximum level.

• Ensure Photocell is covered and if necessary adjust the photocell
sensitivity.

If No,

• Confirm that the PoE injector unit is fully functioning.

NB: Refer to manufacturer’s guide

• Check that the cable is fully intact, and not broken or split.

Step 2: Set-up Camera, lens and illumination

Check alignment of lamp

Check camera lens – fully open at night & set correctly.

Check model number to Raytec performance specification to ensure
required distance is achievable.

Step 3: Call Raytec for further assistance

Note down:

• Model and serial number of illuminator

• Camera make and model

• Lens make and model

If the Raytec lamp is still not delivering the required performance, please
contact us for further assistance: tel [phone]

UK / Europe
T: [phone]
F: [phone]
[e-mail]

Americas (Toll Free)
T: [phone]
[e-mail]

www.rayteccctv.com

PoE/13/6.1