Raytec PSU-VAR-20W-1, PSU-VAR-50W-2, PSU-VAR-100W-2, PSU-VAR-150W-3 Installation & Setup Manual

Installation and Setup Guide for
the VARIO PSU

PSU

Designed to power all VARIO illuminators (including VARIO IP)

PSU-VAR-20W-1 (small) PSU-VAR-50W-2 (medium)

PSU-VAR-100W-2 (large) PSU-VAR-150W-3 (x-large)

Contents

Page 2 - 3 Installation
Page 4 Setup
Page 5 VARIO Standard Bracketry
Page 6 VARIO PSU Specifications
Page 7 - 8 Troubleshooting

2

www.rayteccctv.com UK / Europe Tel: [phone]

Americas Tel: [phone]

Installation

!

Isolate mains before
removing PSU cover

Install in a well
ventilated area

Do not continually

stare at lamp

1.5 m

Mount PSU to

flat surface

Warnings

1

1m - 9m

(3.3ft - 29.5ft)

Approx

Mains Lead

2

3

!

CAUTION:

Red = +ve
Black = -ve

(polarity sensitive)

Photocell

Cable

Breather

Gland

1 Select interchangeable lens and

mount VARIO illuminator

VARIO is factory set and delivered with a
35˚ beam width. To alter to 10˚, simply
remove interchangeable holographic
diffuser (IHD). To alter to 60˚, replace with
other IHD supplied.

2 Mount PSU

Mount PSU on wall/flat surface with
glands facing down

3 Connect illuminator to PSU

VARIO PSU provides 24V DC

Wiring – six core cable

Red wire +
Black wire -

Installers can extend or reduce lead

length using appropriate cable and
weather proof box

3

www.rayteccctv.comUK / Europe Tel: [phone]

Americas Tel: [phone]

4 PSU Connections

Connect photocell following output/telemetry if required into ‘Fast Connect’ wiring terminal.

Photocell following contact - White & Yellow wires

Volt free output. Non polarity sensitive.
Terminal 1 – white wire
Terminal 2 – Yellow wire

Telemetry input - Orange & Purple wires

Volt free/dry contact or TTL input
Terminal 3 – Orange wire
Terminal 4 – Purple wire

5 Connect PSU to mains

CAUTION: Ensure cable glands and PSU lid are water tight by tightening the fixings

Golden Rules

Ensure PSU lid orientation has warning label in line
with glands (see PSU diagram, right)
Ensure PSU is fully water tight

!

WARNING

Automotive blade

output fuse

High quality IP66

aluminium enclosure

Slowblow
input fuse

Mains Input

‘Fast-Connect’

wiring terminal:

inc. telemetry input

and photocell

following output

Cat5

Connector

Glands x 5

White-Light LED

status indicators

Illuminator

Outputs 1+ 2

Image featuring PSU-VAR-50W-2 (medium)