HW1122
USER'S MANUAL
Bathroom Vessel Sink
HW1122
Package List
2
x1
x1
x2
x2
x1
x1
x1x1
x1
x2
x2x2
x1
adapter
1/2 to 3/8
x2
x1 x1
x2
adapter
1/2 to 9/16
x2
3
Installation Instruction
Metal gasket
3
Metal nut
Metal screw
1
4
2
Plastic gasket
Plastic cap
Plastic solenoid
5
6
Note: These fixings are suitable for solid walls only. Plasterboard or stud walls may require
specialist fixings(not supplied).Caution: Care should be taken when drilling walls and floors
to avoid any sunken wires or pipes.
Plastic solenoid
5
1. Drill two holes in the required position on
the wall using a 14mm masonry drill bit, to
a depth of 75mm
Metal screw
1
3. Screw a fixing bolt into each fixing plug using
a 8mm spanner until the spanner contacts the wall.
Metal nut
4
5. Screw a metal nut each fixing bolt to secure the
basin. Caution :Do not over tighten, as this may
damage the ceramic.
2.Push a wall plug into each hole
Plastic gasket
2
Metal gasket
3
4. Place the basin in position against the wall,
iocating the fixing bolts through the holes in
the rear of the basin. Push a plastic washer,
followed by a metal washer, onto each fixing bolt
Plastic cap
6
6.Cover with plastic cap.
Basin&Faucet Installing
4
step1 step2
step3
plastic ring
sink
Thin plastic ring
plastic ring
Metal ring
step4
Metal ring
Thin plastic ring
Finally, apply a circle of glue to the
inner wall of the sink's collector nozzle.
Thicken plastic ring
Small
plastic ring
Tip&Warnings
Don’t over-tighten the water lines. lt could damage the faucet. Certain dimensions of your
vanity must be exact.The diameter of the taping hole needs to be 1 3/8 in.The gap betweem
the taping hole and the drain hole needs to be 10 3/4 in.
2
Loading...