Raypak 206-407 User Manual

Job: Engineer: Contractor: Prepared By: Date:

Versatile

• For use with pool and spa heaters

• Permits sidewall venting

• Allows use of vent pipe as small as 4 in.

diameter

Efficient

• Maintains thermal efficiency of 82% on all heater sizes

Multi-Position Capability

• 90° elbow can be rotated to align fan discharge with vent pipe and reduce the number of fittings required

D-2 Power Vent

For Pool & Spa Heaters

Models 206-407

Features

 Induced draft  Vent (Category III) runs up to 100 ft. equivalent length  Plenum sized for appliance capacity  Air flow proving switch, mounted and wired  Fan motor relay, mounted and wired  240/120 Volt, 60 Hz, 1.95/1.0 Amp, 130 CFM Max.,

3200 RPM motor; Factory-wired for 240 Volt

 90° elbow is used as a termination cap for

horizontal venting

 Heavy-duty galvanized steel cabinet  PolyTuf textured powder coat finish  Indoor/Outdoor construction  Easy installation  Limited one-year warranty  Shipped loose for field mounting

Catalog No.: 1000.70A Effective: 10-15-07 Replaces: 5-1-05

D-2 Power Vent

For Heater Models 206-407 Heater Model

18-1/8

7-7/8

4" DIA

11-5/8

Heater

Model

206/207 009832 12-3/8 4-1/4 266/267 009832 12-3/8 4-1/4 336/337 009833 18-1/8 7-1/4 406/407 009833 18-1/8 7-1/4

* Part numbers are for 240 VAC units.

Consult factory for 120 VAC units.

NOTES:

1. All units can exhaust flue gases horizontally or vertically at up to 100 ft. of equivalent length vent pipe

- 90° elbow = 10 ft. equivalent length

- 45° elbow = 5 ft. equivalent length

2. Vent pipe must meet Category III appliance venting requirements.

3. Vent pipe sizes are based on 400°F nominal flue temperature and sea-level operation. For installation under other conditions, please consult the factory.

Power Vent

Part No.*

Dimensions (in.)

B D

Catalog No.: 1000.70A Effective: 10-15-07 Replaces: 5-1-05