Raypak 133-1826, H3 - 1631 Parts List

CATALOG NO. 9001.10
Effective: 10-01-07
Replaces: 05-01-01

HOW TO USE YOUR RAYPAK ILLUSTRATED PARTS LIST

The Model Number, of a Raypak boiler, is found on the Rating Plate for the Boiler. Each Model number identifies
the application, the construction and the function of the boiler and provides a positive means of providing information,
both installation and service, and parts in a minimum amount of time. The example, shown below , should be used
as a guide to identifying your boiler.

Model No: H3 - 1631

CURRENT

TYPE

DESIGNATION

H1 MECH MOD T 133-1826 150-210
H2 MOTOR MOD TA 514-4001 160-260
H3 TWO-STAGE TB 181-4001 130-230
H4 ON/OFF TC 181-4001 100-240
H5 LOW TEMP MOD TD 400-1826 110-170
H6 MOTOR MOD TX WITH B-3 514-4001 B6000*

H9 FOUR-STAGE NEW 514-4001 -40-220
WH1 ON/OFF WT, W1 133-4001 100-200
WH2 MECH MOD THWS, W2 133-1826 110-170
WH2 MOTOR MOD THWS, W2 2100-4001 104-220
WH3 TWO-STAGE W3 181-4001 130-230

NH - Obsolete 514-1826

RH - Obsolete MECH MOD

WH ON/OFF - ECONOPAK N/A 90-403 105-205

FIRING MODE

MECH MOD TIP OR THWS WITH TIP

(INSTANTANEOUS) AT END OF S/N

Raytherm Type Designations

OLD TYPE

DESIGNATION

TIPR OR THWS WITH

TIPR AT END OF S/N

MODELS

514-1125 150-210

CURRENT TYPE

TEMPERATURE

RANGE

110-170

P ON/OFF - POOL WG 514-4001 40-105

Now find the part you need in the exploded view drawing. After you find the part you will notice a number and letter next to
the part. See Drawing below. This is referred to as a "Call Out".

2-V

The number serves as a "Finder" number and has no specific part classification.
The letter serves as a "Part Class" identification number. The letters stand for specific groups of parts - see Example below.

B - BURNER TRAY M - MISCELLANEOUS
C - CONTROLS P - PILOT
G - GAS VALVES R - REFRACTORY
H - HEAT EXCHANGER S - SHEET METAL

J - J-BOX (CONTROL BOX) V - VENTING
To find the Raypak Part Number, refer to the parts list located on the page opposite to the exploded view drawing.
Now take the call-out you found in the exploded view and match it to the call-out in the left hand column. You will notice the

parts are to groups. These are grouped into "Part Classes". See Example below.

Call-Out Column

H Class

You will also notice that some of the call-out's are indented. The indentations represent parts that are included in the
assemblies listed directly above the indentation. You can order the complete assembly or the indented parts separately
. If the part or assembly does not offer separate parts there will be no indentations.

Assembly 6-B Burner Tray w/Burners

7-B Manifold - Lower

Parts included in Assembly 8-B Manifold - Upper

9-B Burner Hold Down Bracket
10-B Burner Spacer

Raypak, Inc., 2151 Eastman Ave., Oxnard,CA 93030 [phone], FAX [phone]

www.raypak.com Litho in U.S.A.