Raymond weil RW SPORT DUAL TIME User Manual

RAYMOND WEIL S.A.

Avenue Eugène Lance 36 38
P.O. Box 1569
1211 Geneva 26
Switzerland
Tel: [phone]
Fax: [phone]

- -

RECOMMENDATIONS

Your RAYMOND WEIL watch is powered by a battery with
an average life of approximately 36 months. In order to
make the battery last longer, pull the crown out to position 3
whenever you do not intend to wear your watch for a while.

Once exhausted, the battery should be replaced without
delay, in order to avoid any risk of damage to the movement.

Please have your watch battery changed only by an
approved RAYMOND WEIL dealer.

G E N E R A L I N F O R M A T I O N

info@raymond weil.ch

A F T E R S A L E S S E R V I C E

customer service@raymond weil.ch

W E B S I T E

www.raymondweil.com

-

- -

NOTICE

Disposal of a watch by non compliant meth
ods may cause harm to the environment and
is heavily fined according to the regulations

established by each one of the EU member
countries in application of the Directive on Waste Electrical
and Electronic Equipment (Directive 2002/96/EC WEEE).
Should you need to dispose of an old watch, please set it
aside for separate waste collection or give it to a retailer
when purchasing a new watch.
RAYMOND WEIL and its approved dealers are at your
disposal to provide you with additional information on
the subject.

- -

I N ST R U C T I O NS F OR U S E

R W S P O R T D U A L T I M E

INTRODUCTION

e congratulate you on having chosen a watch
from the prestigious RAYMOND WEIL collection,

W

the living expression of masterful design and of
the continuous quest for top quality, which have been the
hallmarks of the Brand since its creation.

A quartz watch enjoys the advantage of being extremely
precise.

In order to guarantee the perfect functioning of your
RAYMOND WEIL watch for many long years, we thank
you to pay close attention to the advice contained in
these Instructions for Use as well as in the Inter
Guarantee booklet.

national

CHANGING THE DATE AND SETTING THE TIME

WATCH HANDS

HOUR

MINUTE

HAND

SMALL SMALL

HOUR MINUTE
HAND HAND

SECOND TIME HANDS

Your RAYMOND WEIL watch may be fitted with a
screw-down crown. Before setting the time or changing
the date, it is therefore necessary to unscrew the crown
by pulling it straight out and turning it anti-clockwise. The
crown will then be released by a spring. After completing
all settings, press lightly on the crown, while turning it
clockwise, and screw it back in gently in order to
preserve your watch’s water-resistance.

HAND

SECONDS

HAND

1

Normal position with
push button
zone setting
Rapid date change

2

Time-setting

3

(first time zone)

SETTING CROWN

PUSH-BUTTON
TIME ZONE SETTING

DATE

: second time

FOR SECOND

CHANGING THE DATE

In order to adjust the date rapidly, pull the crown out to
position 2. Then, depending on the model of your watch,

n the crown forwards or backwards until the desired

tur
date appears in the window.The date changes as the hour
hand passes midnight. With any adjustment effected
between 9 pm and midnight, it is necessary to set the date
on the following day. During this operation, your watch will
continue to function and so will not need to be reset.

Changing the date too rapidly can result in the wrong date
being displayed. Synchronization is restored by setting the
date to the previous day after running through the full
calendar.

After finishing your changes, always push the crown
back in to position 1

, in order to preserve your watch’s

water-resistance.

SETTING THE TIME

In order to adjust the time, pull the cr

own out to position 3

and turn it forwards or backwards until the hands indicate
the desired time.

After setting the time, always push the crown back in to
position 1, in or

der to restart the hands and to preserve

your watch’s water-resistance.

In order to set the time to the nearest second, pull the
crown out to position
to 60. Then, push the crown back in to position 1 at the

3 when the seconds hand points

correct time to the nearest second (do this in conjunction
with a radio signal or a radio-controlled clock, etc.).

SETTING THE SECOND TIME ZONE

The current time is indicated by the hour and minute hands.

The second time runs in parallel with the current time.

In order to adjust the second time, activate the setting
mode by pr
This mode is activated as soon as the small minute hand
jumps forwar

essing the push-button for at least 2 seconds.

d 1 minute.

- A short push (less than 1 second) advances the
refer

ence time in minute intervals.

- A medium push (1 to 2 seconds) advances the

ence time in hourly intervals.

refer

- A long push (more than 2 seconds) advances the

ence time until the push-button is released.

refer

After a few seconds the second time is set.