Raymarine Belgium Bvba T120 916 User Manual
Wind Transmitter
Tacktick Limited
22 North Street, Emsworth,
Hampshire, PO10 7DG, England
Tel. +44 (0)1243 379331
Fax. +44 (0) 1243 379199
www.tacktick.com
Tools Required Parts List
1. Drill Bit
2. Power Drill
3. Cross Head Screwdriver
1. Masthead Mounting Plate
2. Wind Transducer
3. Mounting Screws (3 off)
Precautions
Carry out the “Auto Network” procedure and make sure the unit is
operating correctly BEFORE attaching the Wind Transmitter to the
masthead. Ensure that there is enough surface area at the top of the mast
to attach the Transmitter Base. Check to make sure that the vane and
anemometer cups are moving freely.
Positioning Advise
Wind Transmitter
Tacktick Limited
22 North Street, Emsworth,
Hampshire, PO10 7DG, England
Tel. +44 (0)1243 379331
Fax. +44 (0) 1243 379199
www.tacktick.com
Tools Required Parts List
1. Drill Bit
2. Power Drill
3. Cross Head Screwdriver
1. Masthead Mounting Plate
2. Wind Transducer
3. Mounting Screws (3 off)
Precautions
Carry out the “Auto Network” procedure and make sure the unit is
operating correctly BEFORE attaching the Wind Transmitter to the
masthead. Ensure that there is enough surface area at the top of the mast
to attach the Transmitter Base. Check to make sure that the vane and
anemometer cups are moving freely.
Positioning Advise
uu043 rev. 7
uu043 rev. 7
Installation Method
1. Complete the auto-networking procedure (described on the
yellow instruction sheet) at deck level and ensure that Wind
Speed and Angle are being displayed on the instruments.
2. Get an authorised dealer to ascend the mast and carefully mark
and drill the three mounting holes using the supplied Template.
Care should be taken to ensure the Template is positioned facing
forward.
3. Secure the Wind Transmitter to the masthead using the three
self tapping screws provided.
NOTE: It may be necessary to use alternative mounting screws or bolts
depending on the masthead plate.
4. Check for smooth and free operation of the anemometer cups and the
windvane feather before descending to deck level.
WARNING:
Always ensure that you are secured correctly before ascending any mast.
Always attach a safety strap to the masthead whilst you are working and
leave a competent person on deck to assist. If in doubt get a professional
to ascend the mast.
What Next
Refer to the instrument handbook for details on calibration and alignment.
Installation Method
1. Complete the auto-networking procedure (described on the
yellow instruction sheet) at deck level and ensure that Wind
Speed and Angle are being displayed on the instruments.
2. Get an authorised dealer to ascend the mast and carefully mark
and drill the three mounting holes using the supplied Template.
Care should be taken to ensure the Template is positioned facing
forward.
3. Secure the Wind Transmitter to the masthead using the three
self tapping screws provided.
NOTE: It may be necessary to use alternative mounting screws or bolts
depending on the masthead plate.
4. Check for smooth and free operation of the anemometer cups and the
windvane feather before descending to deck level.
WARNING:
Always ensure that you are secured correctly before ascending any mast.
Always attach a safety strap to the masthead whilst you are working and
leave a competent person on deck to assist. If in doubt get a professional
to ascend the mast.
What Next
Refer to the instrument handbook for details on calibration and alignment.
Loading...