Raymarine WIRELESS HANDHELDS & BASE STATION, SMARTCONTROLLER User Manual
Base Station & Wireless Controller Installation Guide
Parts supplied
Base Station
No. 6 size
No. 8 size
Self-tapping
screws
Belt clip assembly
Lanyard
Locating Base Station
S100 Remote Smart Controller
S100 REMOTE
MODE
STANDBY
OR
PILOT
MODE
STANDBY
PILOT
Cradles x2
3 Way
Connector
Cradles x2
AAA batteries x2
Block
Ferrite
SeaTalk Cable
Charging Cable
Fit as high up as possible, in a dry location
Tools Required
Power Drill
Pozidriv screwdriver
1
/8 inch (3.4 mm) drill
7
/
inch (2.7 mm) drill
64
D7682-1
Min 3ft 3in (1m)
D7678-1
Base Station & Wireless Controller Installation Guide Base Station & Wireless Controller Installation Guide
Fitting Base Station
Remove cover
1.
2
1
3.
Drill two
holes for the fixing screws
7
/
inch (2.7 mm) pilot
64
2.
Mark holes for the fixing screws.
Countersink the pilot holes to prevent
4.
damage to the mounting surface
Connecting Base Station
Important:
Before connecting the Base Station, ensure that the 12 V supply on the asscociated SeaTalk
system is protected by a 5 A fuse.
Base Station
Connect to
Raymarine
SeaTalk
system
Note:
If necessary, you can remove the SeaTalk connector from the Base Station cable,
to make direct connections to SeaTalk, e.g. at a Raymarine course computer.
SeaTalk color coding:
Yellow : SeaTalk data
Red: +12 V
Screen: 0 V
For example,
connect to an
unused SeaTalk
connector on an
instrument
Or use the SeaTalk
connector block
supplied to connect
to a SeaTalk bus
SeaTalk bus
SeaTalk bus
Connector block
D7681-2
5.
Use the two No. 6 screws to secure the
Base Station to the mounting surface
Replace cover
6.
D7676-1
Clip ferrite onto cable, near to connector
Connect cable via 2 A fuse to 12 V supply
2 A fuse
Red
Black
+12 V
0 V
Fitting batteries to S100 Remote Connecting Smart Controller charging cable
Fit 2 x AAA batteries (supplied).
When replacing, use only
high-quality alkaline,
AAA size batteries.
D7504-1
Loading...