RAVE Sports Bongo 20 Bouncer Water Park User Manual

Aqua Jump® Eclipse™ Bongo 20

(Models AJ150/AJ200 and Bongo 20)

Anchor Harness Instruction

Manual

www.ravesports.com

Copyright ©
All rights reserved. No part of this publication may be reproduced or transmitted in any form
or by any means, electronic or mechanical, including photocopy, recording, or any
information storage and retrieval system, without permission in writing from the publisher.
Requests should be mailed to RAVE Sports, 3325 Labore Road, Saint Paul, Minn 55110.

Preparation

Lay the Aqua Jump Eclipse or Bongo 20 on a flat surface. Make sure
there are no sharp objects under the product that might puncture the
tube. Ensure the tube is completely opened and the top is facing
Locate the valve and inflate the tube to about 2/3rds full (The
harness will be the first item to be attached. Do not attach the
and springs to the tube at this time).

anchor

surface

up.

While standing inside the partially inflated tube, spread the Anchor
Harness out onto the ground. With the ropes completely spread out,
ensure the ropes are untangled and not crossing each other.

All RAVE anchor harnesses are made using an “offset” design with a
swivel. This allows maximum holding force in high winds.

The AJ150 Anchor Harness will have one long rope running THOUGH
the hole in the nylon glide assembly and one

shorter rope tied directly

to the other side of the nylon glide.

The AJ200/Bongo20 Anchor Harness has one long rope and one shorter
rope but both ropes pass freely through the left/right holes of the nylon
glide assembly. The glide must be free to slide along both ropes in
order to maintain equal tension on all ropes, regardless of wind
direction. Ensure both ropes are not tangled or crossed and that the
glide is free to slide along both.

Installation

With the Anchor Harness evenly spread out inside the tube, identify
between the long anchor harness rope, and the short rope.

Identify the size of product you have to the diagrams on the next
page. Connect the end of each rope to the corresponding panel of the
Aqua Jump/Bongo. If you are unsure as to the size of the product you
own,
the

count the number of panels on your inflatable tube, and match

number of panels to the diagram.

1 2