RAVE Sports Bongo 15 Bouncer Water Park User Manual

Bongo 15

Anchor Harness

Instruction Manual

A Revel Match, LLC Company

www.ravesports.com

Copyright ©

All rights reserved. No part of this publication may be reproduced or transmitted in any form or
by any means, electronic or mechanical, including photocopy, recording, or any information
storage and retrieval system, without permission in writing from the publisher. Requests

should be mailed to RAVE Sports, 3325 Labore Road, St. Paul, MN 55110.

Preparation

Ensure the 15 foot Bongo is completely opened and the bottom of the tube
is facing up.

With the Bongo still deflated, locate the 3 Anchor Plates with O-rings on the
tube.

Spread the Anchor Harness out onto the ground. With the ropes completely
spread out, ensure the ropes are untangled and the long rope is able to slide
smoothly through the nylon glide freely.
Note: The short rope is permanently tied to the other side of the glide.

Installation

With the Anchor Harness evenly spread out inside the tube, identify
between the short harness rope, and the long harness rope.

The diagram on the following page indicates the exact location to attach
each end of the Anchor harness clips directly to each ring on the inside
perimeter of the Bongo tube. The dark shaded panels are the blue panels on
your product.

NOTE:

The 15 foot Bongo Anchor Harness will have only 3 attachment points. It is
important to connect the short harness rope to the proper anchor ring on
the tube in order to ensure proper operation of the harness.

1

2