
CommandCenter® Secure Gateway Release 5.1.0
Contents
Introduction ............................................................................................................................. 2
Applicability.............................................................................................................................. 2
Upgrade Path...........................................................................................................................2
About Licensing ...................................................................................................................... 3
New Features and Updates in This Release.................................................................5
Minor Features & Maintenance.........................................................................................6
Security and Compliance Information ........................................................................... 7
Updated Product Documentation.....................................................................................7
General Notes.......................................................................................................................... 7
Limitations and Restrictions .............................................................................................. 8
(Note – numbers in parentheses throughout this document are reference numbers internal to Raritan.)
CC-SG 5.1.0 Release Notes Doc. #
255-80-0005-00 Page 1 of 9

Introduction
These Release Notes contain important information regarding a new release
of this product. Please read the entire document and the related
documentation available for this release.
Release 5.1.0 includes several enhancements and maintenance items. It also
establishes a common release for both the Hardware Appliance and Virtual
Appliance.
Release 5.1.0 documentation and upgrade firmware is available at
http://www.raritan
.com/support/commandcenter-secure-gateway/.
Applicability
Hardware Appliance
CC-SG 5.1.0 is applicable to CommandCenter ® Secure Gatew ay
hardware models CC-SG-V1 and CC-SG E1 only.
Important note for CC-G1 customers: Raritan discontinued the CC-G1
model in June of 2007. Do not attempt to upgrade your CC-G1 to this
release. Please back up your CC-G1, restore the database to a CC-SG V1
or E1 hardware unit running the same firmware version, and upgrade the
new V1 or E1 hardware unit to this release per the Upgrade Path
instructions below.
Virtual Appliance
CC-SG 5.1.0 is applicable to Virtual CommandCenter ® Secure Gateway.
Customers running release 5.0.5 may upgrade to version 5.1.0. Note that
release 5.0.5 was the introductory version of the virtual appliance and
does not run on the hardware models.
Upgrade Path
To upgrade a hardware appliance to this release you must be running
firmware version 5.0.0 (hardware appliance) or 5.0.5 (virtual appliance), as
depicted in the diagram below. There may also be additional upgrade steps to
take, depending on your current version. As indicated above, you can
upgrade CC-SG V1 or CC-SG E1 but not CC-G1 units to 5.1.0.
CC-SG 5.1.0 Release Notes Doc. #
255-80-0005-00 Page 2 of 9

Hardware Appliance
3.0.2 3.1.0
3.1.1
3.2.0
3.2.1
4.0.0.5.5
Or
5.0.0
5.1.0
Virtual Appliance
5.0.5 5.1.0
4.0.1.5.3
Or
4.1.0.5.10
Or
4.2.0.5.17
Or
4.3.0
5.0.0
5.0.0
5.0.0
5.0.0
5.1.0
5.1.0
5.1.0
5.1.0
Please back up your CC-SG before and after any upgrade step. For detailed
step by step instructions on upgrading, refer to the Readme file available with
this CC-SG release. You may also need to upgrade your other Raritan devices.
For a complete list of supported devices, refer to the CC-SG Compatibility
Matrix. For instructions on upgrading managed Raritan devices, refer to the
CC-SG Administrators Guide.
About Licensing
(Note – this section applies only to hardware appliance upgrades from
pre-5.0.0 versions; all others can disregard).
In release 5.0.0, new licensing features were introduced in CC-SG. Licenses
are now established and tracked through the new License Manager, located in
the Administration menu of the Administration Client.
As seen in the upgrade path diagram above, if your unit is running a version
lower than 5.0.0, you must upgrade to 5.0.0 before moving up to 5.1.0.
The Licenses will be created during this step.
During the upgrade process, CC-SG will establish a 128 node base license and
will also build any applicable “add-on” licenses needed, based on the
quantity of nodes in the unit’s database. If there are more than 128
nodes in the database, a second license known as an “Add-On” license is
CC-SG 5.1.0 Release Notes Doc. #
255-80-0005-00 Page 3 of 9