Rapoo Technology M6161G User Manual

Quick Start Guide of

2.4GHz Wireless Mouse

Installation

1. Plug the Micro receiver into a USB port of your computer.

2. Open the battery door and install battery.

Mouse Functions

Caution! Before connecting the mouse with the receiver, you need to keep the mouse at

a distance of less than 2 meters to the receiver to finish the initial connection

.

Trouble Shooting

1. Check Micro receiver connection; try to inserting Micro Receiver to another USB port on
your computer.

2. Connection between the mouse and the Micro Receiver. Re-insert the Micro Receiver.
Take out the battery and reinstall it.

FCC Statement

This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference

to radio or television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following measures:

-Reorient or relocate the receiving antenna.

1/2

P/N 266-81610-2009

-Increase the separation between the equipment and receiver.

-Connect the equipment into an outlet on a circuit different from that to which the receiver is

connected.

-Consult the dealer or an experienced radio/TV technician for help.

To assure continued compliance, any changes or modifications not expressly approved by the
party responsible for compliance could void the user’s authority to operate this equipment.
(Example- use only shielded interface cables when connecting to computer or peripheral devices).

This equipment complies with Part 15 of FCC RF Rules. Operation is subject to the following two
conditions:

1) This device may not cause interference and

2) This device must accept any interference, including interference that may cause undesired

operation of the device.

Caution!

The manufacturer is not responsible for any radio or TV interference caused by unauthorized
modifications to this equipment. Such modifications could void the user authority to operate the
equipment.

2/2

P/N 266-81610-2009