Rapoo Technology M6126GII User Manual

1. Check to see if the batteries in the mouse are installed

correctly. Make sure the polarity of the batteries
corresponds with the polarity signs in the battery
compartment.

2. Replace the batteries to make sure the batteries are not
low on power.

Federal Communications Commission (FCC)
Notice

This device complies with Part 15 of the FCC rules. Operation
is subject to the following two conditions:

1) This device may not cause harmful interference, and

2) This device must accept any interference received,

including interference that may cause undesired
operation.

CAUTION!

The manufacturer is not responsible for any radio or TV
interference caused by unauthorized modifications to this
equipment. Such modifications could void the user authority to
operate the equipment.
P/N: 266-80260-2008

4

2.4GHz Wireless Super Mini Mouse

Quick Start Guide

Of

Installation

1. Plug the Nano receiver into a USB port of your
computer.

2. Push the Battery Cover Switch aside, open the battery
door and install battery, then close the battery cover.

Receiver storage and ON/OFF the mouse

1. You can store or take out the Nano receiver from the
Nano receiver storage by push/pull the Nano receiver.

2. You can switch On or shut off the mouse by use the
ON/OFF switch on the bottom of the mouse.

2

Mouse Functions

Speed Control

Press the CPI button and you can toggle the CPI between 800
CPI and 1600 CPI.

Trouble Shooting

1. Check Nano receiver connection; try to insert Nano
Receiver to another USB port on your computer.

3