2.4GHz Wireless Super Mini Mouse
P/N: 266-80260-2008
Quick Start Guide
Of
Installation
1. Plug the Nano receiver into a USB port of your
computer.
2. Push the Battery Cover Sw itch asid e, ope n t he b attery
door and install battery, then close the battery cover.
Receiver storage and ON/OFF the mou se
1. You can store or take out the Nano receiver from the
Nano receiver storage by push/pull the Nano receiver.
2. You can switch On or shut off the mouse by use the
ON/OFF switch on the bottom of the mouse.
2
Mouse Functions
Speed Control
Press the CPI button and you can toggle the CPI between 800
CPI and 1600 CPI.
3
Trouble Shooting
1. Check Nano receiver connection; try to insert Nano
Receiver to another USB port on your computer.
2. Check to see if the batteries in the mouse are installed
correctly. Make sure the polarity of the batteries
corresponds with the polarity signs in the battery
compartment.
3. Replace the batteries to make sure the batteries are not
low on power.
4 1
Note:
FCC statement
This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to provide reasonable
protection against harmful interfer ence in a residential
installation.
This equipment generates, uses and can radiate radio
frequency energy and if not installed and used in accordance
with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that
interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or
television reception, which can be determined by turning the
5
equipment off and on. The user is encouraged to try to correct
the interference by one of the following measures:
Reorient or relocate the receiving antenna.
Connect the equipment into an outlet on a circ uit di fferent from
that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for
help.
To assure continued comp lianc e, any changes or modifications
not expressly approved by the party responsible for
compliance could void the user’s authority to operate this
equipment. (E xample- use only shielded inter fa ce cabl es when
connecting to computer or peripheral devices).
This device complies with Part 15 of the FCC rules. Operation
is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received,
including interference that may cause undesired operation.
Caution!
The manufacturer is not responsible for any radio or TV
interference caused by unauthorized modifications to this
equipment. Such modifications could void the user authority to
operate the equipment.
Loading...