Rapoo Technology M605HG User Manual

MLK Industries (ShenZhen) Limited Rev:1.00 2009.5.10

Quick Start Guide of

Installation

1. Plug the Nano receiver into a USB port of your computer.

2. Push battery cover back first,and then pull it down to open the battery door.

3. Insert 2 AAA batteries. Place back the battery cover.

4. Install the driver (required for programable button).

5. Open software from the start menu. Please click “HELP” if you have any
questions.

2.4GHz Wireless Remote Control Mouse

2.

1.

Mouse Functions

Interchangeable Top-Cover

Press the eject button to take away the top-cover L,and then you can put
another top-cover M on the mouse.

Flip 3D

Press this button to switch from different windows.It’s the same function with “Alt+Tab” in
keyboard.

Green LED

1/3

P/N 266-81830-2009

MLK Industries (ShenZhen) Limited Rev:1.00 2009.5.10

When switch the power ON, this LED will flash for 5 seconds. And If the power
is low, this LED will flash too

Speed Control

Press the DPI button and you can toggle the DPI between 800 DPI and 1600
DPI.

Universal Back / Forward

Use the back button to access previous page and use the forward button to
access next page.

On/Off the mouse

Switch on or shut off the mouse by using the On/Off switch at the bottom of the
mouse.

Trouble Shooting

1. Check Nano receiver connection; try to inserting Nano Receiver to another
USB port on your computer.

2. Connection between the mouse and the Nano Receiver. Re-insert the Nano
receiver. Take out the battery and reinstall it.

FCC Statement

This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference
by one or more of the following measures:

-Reorient or relocate the receiving antenna.

-Increase the separation between the equipment and receiver.

-Connect the equipment into an outlet on a circuit different from that to which

the receiver is connected.

-Consult the dealer or an experienced radio/TV technician for help.

To assure continued compliance, any changes or modifications not expressly
approved by the party responsible for compliance could void the user’s
authority to operate this equipment. (Example- use only shielded interface
cables when connecting to computer or peripheral devices).

2/3

P/N 266-81830-2009