Rapid2
Medium duty tyre rack
Assembly instruction
AIST011
If you have any problems whatsoever please call 01285 686868
where a team of experts will be pleased to help.
RAPID 2 MEDIUM DUTY TYRE RACK
Multiple packages
IMPORTANT - ASSEMBLY INSTRUCTIONS
AIST011
1 Fit feet D to uprights A.
2 Assemble both ends first - A and B. Starting
from the top insert beam B in the top two holes
of the uprights, tap in place with a rubber
mallet. Insert the second beam leaving 9 clear
holes. Insert the third beam leaving 16 clear
holes. Insert the bottom beam leaving 1 clear
hole for the plastic feet.
3 Tap together using rubber mallet.
4 Fit front and rear beams C to uprights A, level
with side beams B. There is no front or rear
beam attached to the top of this bay next to
the top side beam B.
5 Add caps E.
ASSEMBLY
We advise the use of protective
gloves and goggles, or eyeglasses
when assembling this product.
Tools required: Rubber mallet
Tyre Rack in use
A
A
B
B
C
C
D
E
The beam slots are tapered
and fit into the slots
as shown
C
M
Y
CM
MY
CY
CMY
K
If you have any problems whatsoever please call 01285 686868 where a team of experts will be pleased to help.
Uprights
COMPONENTS
RAPID 2 MEDIUM DUTY TYRE RACK
Multiple packages
IMPORTANT - ASSEMBLY INSTRUCTIONS
AIST011
A
Keep heavier items
on the bottom shelves
Do not climb
on your shelving
Make sure it is on a
level and even floor
Keep your
shelving dry
Tie plates recommended
with more than one bay
x4 per joint
B
Side beams
380mm
8 of
SAFETY
198 0 mm
4 of per bay
D
Feet
4 of
C
Front and rear beams
915 mm, 1220 mm and 1525mm
6 of
E
Caps
4 of
Loading...