RapidMesh RMWSL0227 Assembly Instructions Manual

1300 911 914 | [e-mail] | www.rapidmesh.com.au

RMWSL0227 Above Bonnet Storage

Assembly Instructions

Additional Tools Required;

Hardware included;

10 x 50mm Hex Head Screws
23 x 60mm Hex Head Screws
2 x 70mm Hex Head Screws
17 x 80mm Hex Head Screws

Components included;

Roof x 2

Floor x 2

Front Panel x 2

Door x 2

Back Panel x 2

Side Panel x 2

Corner Legs x 4

Centre Leg x 1

Cantilever Support x 1

Joining Bracket x 1

47 x Nut

5 x Flanges

1300 911 914 | [e-mail] | www.rapidmesh.com.au

Step 1.

Unpack the unit and confirm
you have all the parts listed.

Assembly

Entire set up is to be done on level ground.
Requires 2-person assembly.

Step 2.

Loosely fix all Floor, Side, Back, Door
and Roof Panels using the screws and
nuts provided.

Step 3.

Fix all Legs, Cantilever Support and Joining Bracket
to the unit using the screws and nuts provided.

Step 5.

Use bolts provided to fix the legs into the flanges.
Move in to position and fix the flanges to the floor
(hardware not included).
For stability fix unit to a wall (hardware not included).

Step 4.

Tighten all screws.

Our goods come with guarantees that cannot be excluded under the Australian consumer law. You are entitled to a replacement or refund for a major
failure and compensation for any other reasonably foreseeable loss or damage. You are also entitled to have the goods repaired or replaced if the goods
fail to be of acceptable quality and the failure does not amount to a major failure. This warranty excludes damage resulting from product misuse or product
neglect. The warranty covers domestic use only and does not apply to commercial application. This warranty is given by Rapid Hardware Group Pty Ltd,
ABN 71145292646, 2 Park Drive, Dandenong South VIC 3175.

Note:

The above image depicts an exploded product
view and is to be used for illustration purposes.

RMWSL0227 Above Bonnet Storage