Rapid Electronics 400S Owner's Manual
. .
314
TABLE OF CONTENTS
400SOM 01/05
A. REMOTE TRANSMITTER OPERATION ..............................................5
B. LED DISPLAY ..............................................................................6
C. CHIRP INDICATOR.......................................................................6
D. PARKING LIGHT..........................................................................6
E. ALARM OPERATION CONDITION....................................................6
F. ACTIVE ARMING ARM & LOCK..................................................6-7
Ajar Warning
Silent Arming / Disarming
Shock Sensor By-Pass
Noiseless Mode
Hidden Alarm Function
G. PASSIVE ARMING.....................................................................7-8
Passive Door Locking
Passive Arming By-Pass
H. ACTIVE DISARMING UNLOCK & DISARM......................................8
Tamper Disarming
Pathway Illumination
Two Steps Door Unlock
Automatic Rearm
I. DISARMING WITHOUT A TRANSMITTER ....................................9-10
Overrides the Alarm without Password Pin Code
Overrides the Alarm With Password Pin Code
J. VALET MODE .............................................................................10
Enter Valet Mode
Exit Valet Mode
Remote Valet Mode
K. CAR FINDER .............................................................................10
L. PANIC FUNCTION .................................................................10-11
M. TRIGGER THE SYSTEM...............................................................11
Clear The Trigger Icons and Melody Sound
. .
134
TABLE OF CONTENTS
N. ANTI CAR- JACKING ..................................................................12
Active Car Jacking
Passive Anti Car Jacking
Trigger The Anti Car Jacking Mode
Override The System To Turn Off Anti Car Jacking
O. DOME LIGHT CONVENIENCE DELAY & SUPERVISION......................13
P. IGNITION CONTROL THE DOOR LOCK/UNLOCK .............................13
Q. TRUNK RELEASE (CHANNEL 3) OUTPUT........................................13
R. CHANNEL 4 TIMER CONTROL OUTPUT ..........................................13
S. POWER ON MEMORY ..................................................................13
OPERATION
R. CHANNEL 4 TIMER CONTROL OUTPUT
Press the transmitters and buttons at the same time to activate the
Channel 4 function. Channel 4 is a user-programmable timer output.
You may program the built-in timer to send a ground signal for any time
duration from 1 second to 120 seconds. For instance, this timer output may
be used to turn on the headlights, power windows or sunroof. (The factory
default setting is a momentary output.)
S. POWER ON MEMORY:
This security system is equipped with circuitry that will allow the unit to
remember its alarm state if the vehicles battery power is lost then
reconnected.
O. DOME LIGHT SUPERVISION
The alarm has a unique feature which will turn on your vehicles
Dome Light as follows:
1. Upon disarming, the dome Light will remain on for 30 seconds.
2. If the vehicle is intruded, the dome Light will flash for the same duration
as the siren.
Note: Turning ON the ignition switch or arming the alarm will turn
off the dome light.
P. IGNITION CONTROLLED DOOR LOCKING AND UNLOCKING
(See Alarm Feature II-3 Programming.)
1. Turn the ignition switch ON and close all the vehicles doors. After 3
seconds, the system will automatically lock the central locking system.
2. Turn the ignition switch OFF. The system will automatically unlock the
central locking system.
Q. TRUNK RELEASE (CHANNEL 3) OUTPUT.
CHANNEL 3 TIMER CONTROL OUTPUT
(See Alarm Feature III-3 Programming.)
Press and hold the
button on the transmitter for (2) sec. to open the
trunk release or any other electric devices that has been added to this
output.
Channel 3 is user-programmable timer output. You may program the built=in
timer to send a ground signal for any time interval between 1 second and
2 minutes. For instance. this timer output may be used to turn on the
headlights, power windows or sunroof. NOTE: Factory default setting at 1
second pulse grounded for trunk release output.
Loading...