RAPESCO 626EL Operating Instructions

626EL Automatic USB
Electric Stapler

Operating Instructions

Please read the following instructions carefully before operating your stapler

Installing Batteries

To be used under adult supervision only

Connecting your Stapler

This automatic stapler will operate using either batteries (not included) or via a USB
port (cable included).

To operate using the USB cable, insert the connector into the rear of the stapler
marked “USB”. Insert the USB socket preferably into a mains USB plug or alternatively
into your computer USB port.

PLEASE NOTE: If the stapler is connected to a computer USB port, the power
may not be as efficient to fully power the stapler as it would be if the USB was
connected to a mains power outlet.

Using the Stapler

1. Ensure the stapler is placed on a
stable, rigid surface before inserting
any papers.

2. To activate the stapler, simply insert
the paper (max. 15 sheets) into the
opening at the front of the stapler.
Stapling will begin automatically when
paper is inserted.

1. Open the battery
compartment on the bottom
of the stapler.

2. Insert four new AA (1.5V)
alkaline or rechargeable
batteries into the
compartment according to
the diagram making sure to
observe correct polarity.

3. Close battery compartment.

Loading Staples

Back

Front

Dimensions Weight Compatible Staples Capacity

L 131 x W 52 x H 84mm 280g 26/6mm Max. 15 sheets (80gsm)

Release Button

Magazine

1. Ensure there is no paper in the stapling mouth before adding more staples.

2. Press the button at the rear of the stapler to eject the staple magazine channel.

3. Load Rapesco 26/ 6mm staples into the staple channel before gently pushing it
back into the stapler until it clicks into place.

Avoiding Paper Jams

1. A staple jam will occur when the sheet capacity is exceeded. DO NOT
staple more than 15 sheets (80gsm) at any one time.

2. Between each staple allow the stapler motor to fully complete its cycle
before removing the paper from the stapling mouth.

3. DO NOT continue stapling if the batteries appear flat.

Clearing Paper Jams

Back

Release Button

1. Should your stapler jam DO NOT pull
at the paper in the stapler mouth before
following steps 2 & 3 otherwise you will
damage the motor and the stapler.

2. If paper is stuck, remove the power
source (USB cable or batteries), then
press the button at the rear of the
stapler to eject the staple magazine
channel.

3. Gently pull the channel out fully and
remove the jammed paper and staple.

4. Ensure the staples are correctly loaded
before pushing the magazine channel
back into place.

Tips & Warnings

1. Pulling any paper out too quickly or with force will damage the stapler motor
as the movement mechanism is designed to complete a full cycle each time.

2. DO NOT drop the stapler as this will damage the internal working parts.

3. DO NOT mix old and new batteries, always replace all 4 batteries at the
same time.

4. DO NOT mix alkaline or rechargeable batteries due to risk of explosion, all 4
batteries must be the same type.

5. To avoid damage from battery leakage, remove batteries when stapler is not
used for long periods.

6. As with all electrical appliances, keep out of the reach of small children.

7. This stapler is for paper only so do not insert any other objects or material
into the stapler.

8. The supplied USB cable is only compatible with USB 2.0 Type A connectors.

9. Warning – this is NOT a toy.

5. Add/ re-connect your power source
again to continue stapling.

Do not dispose of electrical appliances as unsorted municipal
waste, use separate collection facilities.

Contact your local government for information regarding the
collection systems available.