Randall NBKING100 Owner's Manual

NBKING100

Nuno Bettencourt

Signature Series

QUICK START GUIDE

START UP

After you have plugged in and connected the AC power cord securely from the
wall to the amplier, connect only a high quality speaker cable from the Speaker
output jack to the input jack of your extension cabinet. Make sure that you plug
into the correct Speaker output jack which matches the impedence of your cabinet.
For example: If you have a 16 ohm cabinet then make sure you are plugged into
the jack labeled 16 ohms. Now that the amplier has been hooked up
correctly, simply plug your guitar into the front panel Input jack using a high
quality instrument cable and ip the Power switch to ON.
Once the amplier is powered up it will default to the the Clean channel. Set all
the Drive, Level & EQ controls to straight up except for the large Master
control which should be set all the way down. Turn the amp from Standby to On
then bring up the Master control slowing until you reach the desired volume level.

This
channel is perfect for all clean tones, but really shines for Funk style as well as
vintage blues tones.

FRONT PANEL FEATURES

INPUT

Designed to accept a standard 1/4” mono phone plug. For best results use a
high quality shielded cable to connect your guitar to the amplier.
.

CHANNEL SELECT SWITCH

This momentary push button switch is used to scroll thru and select between the
3 channels on the amplier. Simply push and release to change channelsand select
the desired channel. This switch is also the store function for the included MIDI
footswitch or any MIDI compatible footcontroller. To store a channel to a particular
button on the footswitch, simply press the desired footswitch button then using the
front panel Channel select button scroll thru to the desired channel. Press, hold
& release the Channel Select button for 3 seconds to store the preset. See the
MIDI implemention guide later in this manual.

CLEAN

This channel was designed for a wide-range of dynamic clean tones, but really
shines for all funk to vintage style blues tones.

BASS - This passive tone control adjusts the amount of low frequencies in the
Clean channel. Set the knob straight up then adjust for more or less bass as
needed.

MIDDLE - This passive tone control adjusts a wide-range of the mid-range
frequencies in the Clean channel. When adjusting the MIDDLE control keep
in mind that you will also be cutting and boosting upper bass frequencies and
lower Treble frequencies. Set the knob straight up then adjust as needed.

TREBLE - Another passive tone control that adjusts all upper mid-range and high
frequencies. Set the knob straight up to start then adjust in more or less highs
as needed.

LEVEL - Controls the volume level of only the Clean channel. Set this knob to
achieve the desired output level of the clean channel.