Ramsey 295934, 295935 User Manual

INSTALLATION INSTRUCTIONS FOR
SIERRA GRILLE GUARD KIT # 295934
SIERRA WRAPAROUND KIT # 295935

2003-2007* CHEVY SILVERADO 2500 HD/3500

NOTICE

Ramsey kits are designed for use with Ramsey Winches only.

Use or sales of kits for other winches or applications voids warranty.

WARNING

Ramsey offers mounting kits and winches for various vehicles. In crash tests on a limited number
of automotive manufacturer's vehicles, winches/mounting kits, which have been properly
mounted, have not interfered with air bag operation.

The user/customer, or their installer, must verify that the mounting kit does not interfere with the
factory air bag sensors, which must not be relocated or modified in any way.

The user/customer should follow the vehicle manufacturer's recommendations and those of a
qualified mechanic to determine if the winch/mounting kit might interfere with the air bag
operation. The user/customer should then determine the suitability of a winch/mounting kit on a
particular vehicle.

PLEASE BE ADVISED THAT THE VEHICLE'S AIR BAG SYSTEM MAY NOT OPERATE
PROPERLY IF THE WINCH/MOUNTING KIT IS NOT MOUNTED IN COMPLIANCE WITH THE
VEHICLE MANUFACTURER'S RECOMMENDATIONS.

DO NOT ATTACH TOW HOOK TO ANY PART OF MOUNTING KIT UNLESS INSTRUCTED TO
DO SO.

DO NOT SUBSTITUTE ATTACHING HARDWARE ITEMS (BOLTS, NUTS, OR WASHERS).

READ AND UNDERSTAND WINCH OWNER'S MANUAL BEFORE INSTALLATION AND
OPERATION OF WINCH. SEE WARNING AND CAUTION.

IMPORTANT NOTES!

1. RIGHT AND LEFT HAND DIRECTIONS AS IF SEATED BEHIND STEERING WHEEL.

2. ALL FASTENING HARDWARE MUST BE LOOSELY ASSEMBLED UNTIL DIRECTED TO TIGHTEN.

RAMSEY WINCH COMPANY

P.O. BOX 581510

TULSA, OKLAHOMA 74158

*2007 Classic Series

KI-913378-0307-E

Step 1

Note: It is not necessary to remove or modify the vehicle bumper to install this mounting kit. Remove
and discard the M12 bolts at either side and bottom of the tow hook (Figure 1), remove tow hook and
set aside.

Figure 1

Step 2

Insert left hand frame mounting bracket assembly #7 through air dam. Replace tow hook and secure
using (3) 12 mm bolts #18 (Figure 2). DO NOT TIGHTEN HARDWARE COMPLETELY.

Figure 2

Step 3

Repeat steps 1 & 2 above for right hand side. DO NOT TIGHTEN HARDWARE COMPLETELY.

1

Step 4

Note: You will need assistance for this step.

Have someone hold the center unit while you insert the
winch mounting channel #2 between side plates of center
unit #5. Channel shims #29 are inserted between the end of
the channel and the side plate of the center unit on both
sides. Secure each side of channel using (2) 3/8-16NC x 1
capscrews #16 with nuts #20 (Figure 3).

Step 5

Install upper mounting bracket #11 (Figure 4) on bumper using 3/8” x 1” bolt #16 and secure using
3/8 locknut #20 (Figure 5). Make sure top tab of left hand bracket is pointed toward the left side of
vehicle as shown below. Repeat for right hand side.

Figure 3

Figure 4

Step 6

Mount center unit on vehicle and secure each side at the lower support bracket using (3) 1/2” X 1-1/4”
capscrews #17 with (3) 1/2” nuts #21 (Figure 5). Attach each side of center unit to upper support
bracket using (1) 3/8-16NC x 1 capscrew #16 with nut #20. DO NOT TIGHTEN HARDWARE.

Figure 5

2