Ramsey 2500HD User Manual

INSTALLATION INSTRUCTIONS FOR

SIERRA GRILLE GUARD KIT # 295952

2007 CHEVY SILVERADO 2500 HD/3500

2007 GMC SIERRA 2500 HD/3500

NOTICE

Ramsey kits are designed for use with Ramsey Winches only.

Use or sales of kits for other winches or applications voids warranty.

WARNING

Ramsey offers mounting kits and winches for various vehicles. In crash tests on a limited number
of automotive manufacturer's vehicles, winches/mounting kits, which have been properly
mounted, have not interfered with air bag operation.

The user/customer, or their installer, must verify that the mounting kit does not interfere with the
factory air bag sensors, which must not be relocated or modified in any way.

The user/customer should follow the vehicle manufacturer's recommendations and those of a
qualified mechanic to determine if the winch/mounting kit might interfere with the air bag
operation. The user/customer should then determine the suitability of a winch/mounting kit on a
particular vehicle.

PLEASE BE ADVISED THAT THE VEHICLE'S AIR BAG SYSTEM MAY NOT OPERATE
PROPERLY IF THE WINCH/MOUNTING KIT IS NOT MOUNTED IN COMPLIANCE WITH THE
VEHICLE MANUFACTURER'S RECOMMENDATIONS.

DO NOT ATTACH TOW HOOK TO ANY PART OF MOUNTING KIT UNLESS INSTRUCTED TO
DO SO.

DO NOT SUBSTITUTE ATTACHING HARDWARE ITEMS (BOLTS, NUTS, OR WASHERS).

READ AND UNDERSTAND WINCH OWNER'S MANUAL BEFORE INSTALLATION AND
OPERATION OF WINCH. SEE WARNING AND CAUTION.

IMPORTANT NOTES!

1. RIGHT AND LEFT HAND DIRECTIONS AS IF SEATED BEHIND STEERING WHEEL.

2. ALL FASTENING HARDWARE MUST BE LOOSELY ASSEMBLED UNTIL DIRECTED TO TIGHTEN.

RAMSEY WINCH COMPANY

P.O. BOX 581510

TULSA, OKLAHOMA 74158

KI-913411-0607-A

Note: It is not necessary to remove the vehicle bumper to install this mounting kit.

Step 1

Remove tow hook and set aside (Figure 1). Tow hook and hardware will be reused.

Figure 1

Step 2

Cut around tow hook opening to allow the lower frame mounting bracket (Item #5) to pass through.
(Figure 2)

Figure 2

Step 3

Install lower frame mounting bracket (Item #5) using a ½” t-bolt (Item #12), ½” flat washer (Item # 20),
and ½” locknut (Item #18). (Figure 3) Attach nut loosely.

Note: The t-bolt (Item #12) is installed from inside of the frame down through rear hole of the lower frame
mounting bracket (Item #5).

REAR HOLE OF LOWER
FRAME BRACKET

Figure 3

1