RAM Mount VBD-126-SW1 User Manual

Item Number

RAM-VBD-126

Vehicle base for the

FORD BRONCO (1996-OLDER)
FORD EXPEDITION (1996-OLDER)
FORD F-150 (1996-OLDER)
FORD F-250 (1996-OLDER)

SPECIFICATIONS

Placement

Transmission Hump

RAM Drill Seat Bases

National Products, Inc.

Drilling Required

Yes

Seat Configuration

Bucket/Bench

Construction/Finish

Steel/Black Powdercoat

Dimensions

A = 3.75", B = 8.75", C = 9" D = 4

Features

Low footprint design

Misc.

Rugged Steel Construction
Lifetime warranty

Pole or Pedestal

Sold Separately

Weight

2.9 lbs.

Shown In Use

RAM-VBD-126

National Products, Inc.
Phone: [phone]
Fax: [phone]
Address: 1205 S Orr St
Seattle, WA 98108
Website: www.ram-mount.com
Email: [e-mail]

This document, including images, may not be reproduced partly or fully without the expressed written consent of National Products, Inc.

Item Number

RAM-VBD-126

RAM Drill Seat Bases

National Products, Inc.

Vehicle base for the

FORD BRONCO (1996-OLDER)
FORD EXPEDITION (1996-OLDER)
FORD F-150 (1996-OLDER)
FORD F-250 (1996-OLDER)

INSTALLATION INSTRUCTIONS

1. Determine the best location for the base on the transmission hump.

2. Locate base on hump with floor pan flange orientated on the passenger side of the vehicle. Make sure that the
hump flanges are in contact with the top of the hump.

3. Mark mounting holes and check to see if any edges of the base need to be shimmed.

4. Drill 13/32” holes at each of the marked locations. Please be careful not to damage any equipment that might be
underneath the floor boards.

5. Attach base with bolts, washers, and nuts. Do not use sheet metal screws. If floor is less than 1/4” thick, please use
fender washers to help disperse the weight.

National Products, Inc.
Phone: [phone]
Fax: [phone]
Address: 1205 S Orr St
Seattle, WA 98108
Website: www.ram-mount.com
Email: [e-mail]

This document, including images, may not be reproduced partly or fully without the expressed written consent of National Products, Inc.